Literature DB >> 23179982

In vivo analysis of cervical kinematics after implantation of a minimally constrained cervical artificial disc replacement.

Heiko Koller1, Oliver Meier, Juliane Zenner, Michael Mayer, Wolfgang Hitzl.   

Abstract

INTRODUCTION: To better understand cervical kinematics following cervical disc replacement (CDR), the in vivo behavior of a minimally constrained CDR was assessed.
METHODS: Radiographic analysis of 19 patients undergoing a 1-level CDR from C4-5 to C6-7 (DISCOVER, Depuy-Spine, USA) was performed. Neutral-lateral and flexion-extension radiographs obtained at preop, postop and late follow-up were analyzed for segmental angle and global angle (GA C2-7). Flexion-extension range of motion was analyzed using validated quantitative motion analysis software (QMA®, Medical Metrics, USA). The FSU motion parameters measured at the index and adjacent levels were angular range of motion (ROM), translation and center of rotation (COR). Translation and COR were normalized to the AP dimension of the inferior endplate of the caudal vertebra. All motion parameters, including COR, were compared with normative reference data.
RESULTS: The average patient age was 43.5 ± 7.3 years. The mean follow-up was 15.3 ± 7.2 months. C2-7 ROM was 35.9° ± 15.7° at preop and 45.4° ± 13.6° at follow-up (∆p < .01). Based on the QMA at follow-up, angular ROM at the CDR level measured 9.8° ± 5.9° and translation was 10.1 ± 7.8 %. Individuals with higher ROM at the CDR level had increased translation at that level (p < .001, r = 0.97), increased translation and ROM at the supra-adjacent level (p < .001, r = .8; p = .005, r = .6). There was a strong interrelation between angular ROM and translation at the supra-adjacent level (p < .001, r = .9) and caudal-adjacent level (p < .001, r = .9). The location of the COR at the CDR- and supra-adjacent levels was significantly different for the COR-X (p < .001). Notably, the COR-Y at the CDR level was significantly correlated with the extent of CDR-level translation (p = .02, r = .6). Shell angle, which may be influenced by implant size and positioning had no impact on angular ROM but was correlated with COR-X (p = .05, r = -.6) and COR-Y (p = .04, r = -.5).
CONCLUSION: The COR is an important parameter for assessing the ability of non-constrained CDRs to replicate the normal kinematics of a FSU. CDR size and location, both of which can impact shell angle, may influence the amount of translation by affecting the location of the COR. Future research is needed to show how much translation is beneficial concerning clinical outcomes and facet loading.

Entities:  

Mesh:

Year:  2012        PMID: 23179982      PMCID: PMC3631039          DOI: 10.1007/s00586-012-2583-6

Source DB:  PubMed          Journal:  Eur Spine J        ISSN: 0940-6719            Impact factor:   3.134


  32 in total

Review 1.  Biomechanics of the cervical spine. I: Normal kinematics.

Authors:  N Bogduk; S Mercer
Journal:  Clin Biomech (Bristol, Avon)       Date:  2000-11       Impact factor: 2.063

2.  Biomechanical study on the effect of cervical spine fusion on adjacent-level intradiscal pressure and segmental motion.

Authors:  Jason C Eck; S Craig Humphreys; Tae-Hong Lim; Soon Tack Jeong; Jesse G Kim; Scott D Hodges; Howard S An
Journal:  Spine (Phila Pa 1976)       Date:  2002-11-15       Impact factor: 3.468

Review 3.  Choosing a cervical disc replacement.

Authors:  Helmut D Link; Paul C McAfee; Luiz Pimenta
Journal:  Spine J       Date:  2004 Nov-Dec       Impact factor: 4.166

Review 4.  Artificial disc prosthesis: design concepts and criteria.

Authors:  Casey K Lee; Vijay K Goel
Journal:  Spine J       Date:  2004 Nov-Dec       Impact factor: 4.166

Review 5.  Biomechanics of nonfusion implants.

Authors:  Russel C Huang; Timothy M Wright; Manohar M Panjabi; Joseph D Lipman
Journal:  Orthop Clin North Am       Date:  2005-07       Impact factor: 2.472

6.  Intervertebral motion between flexion and extension in asymptomatic individuals.

Authors:  Charles A Reitman; Kristin M Mauro; Lyndon Nguyen; James M Ziegler; John A Hipp
Journal:  Spine (Phila Pa 1976)       Date:  2004-12-15       Impact factor: 3.468

7.  Primary and coupled motions after cervical total disc replacement using a compressible six-degree-of-freedom prosthesis.

Authors:  A G Patwardhan; M N Tzermiadianos; P P Tsitsopoulos; L I Voronov; S M Renner; M L Reo; G Carandang; K Ritter-Lang; R M Havey
Journal:  Eur Spine J       Date:  2010-09-24       Impact factor: 3.134

8.  Influence of an artificial cervical joint compared with fusion on adjacent-level motion in the treatment of degenerative cervical disc disease.

Authors:  Crispin Wigfield; Steven Gill; Richard Nelson; Ilana Langdon; Newton Metcalf; James Robertson
Journal:  J Neurosurg       Date:  2002-01       Impact factor: 5.115

9.  Sagittal plane segmental motion of the cervical spine. A new precision measurement protocol and normal motion data of healthy adults.

Authors:  W Frobin; G Leivseth; M Biggemann; P Brinckmann
Journal:  Clin Biomech (Bristol, Avon)       Date:  2002-01       Impact factor: 2.063

10.  Changes in segmental intervertebral motion adjacent to cervical arthrodesis: a prospective study.

Authors:  Charles A Reitman; John A Hipp; Lyndon Nguyen; Stephen I Esses
Journal:  Spine (Phila Pa 1976)       Date:  2004-06-01       Impact factor: 3.468

View more
  8 in total

1.  Does sagittal position of the CTDR-related centre of rotation influence functional outcome? Prospective 2-year follow-up analysis.

Authors:  P Suchomel; L Jurák; J Antinheimo; J Pohjola; J Stulik; H-J Meisel; M Čabraja; C Woiciechowsky; B Bruchmann; I Shackleford; R Arregui; S Sola
Journal:  Eur Spine J       Date:  2014-02-20       Impact factor: 3.134

2.  Correlation between cervical lordosis and adjacent segment pathology after anterior cervical spinal surgery.

Authors:  Soo Eon Lee; Tae-Ahn Jahng; Hyun Jib Kim
Journal:  Eur Spine J       Date:  2015-07-22       Impact factor: 3.134

3.  Clinical and radiological outcome 1-year after cervical total disc replacement using the Signus ROTAIO - Prosthesis.

Authors:  Anna Lang; Sara Lener; Lukas Grassner; Anto Abramovic; Claudius Thomé; Dennis Päsler; Jens Lehmberg; Ralph Schär; Sebastian Hartmann
Journal:  Eur Spine J       Date:  2022-10-11       Impact factor: 2.721

4.  Heterotopic ossification and clinical outcome in nonconstrained cervical arthroplasty 2 years after surgery: the Norwegian Cervical Arthroplasty Trial (NORCAT).

Authors:  Jarle Sundseth; Eva Astrid Jacobsen; Frode Kolstad; Ruth O Sletteberg; Oystein P Nygaard; Lars Gunnar Johnsen; Are Hugo Pripp; Hege Andresen; Oddrun Anita Fredriksli; Erling Myrseth; John A Zwart
Journal:  Eur Spine J       Date:  2016-04-09       Impact factor: 3.134

5.  In cervical arthroplasty, only prosthesis with flexible biomechanical properties should be used for achieving a near-physiological motion pattern.

Authors:  Manfred Muhlbauer; Ernst Tomasch; Wolfgang Sinz; Siegfried Trattnig; Hermann Steffan
Journal:  J Orthop Surg Res       Date:  2020-09-09       Impact factor: 2.359

6.  Iatrogenic biological fracture of the cervical spine during gradual halo traction for kyphotic deformity correction: case report.

Authors:  Austin Samuel Laifun Lim; Azizul Akram Bin Sali; Jason Pui Yin Cheung
Journal:  BMC Musculoskelet Disord       Date:  2020-05-21       Impact factor: 2.362

7.  Mid-long-term follow-up of operated level kinematics after single-level artificial cervical disc replacement with Bryan disc.

Authors:  Chuanhong Li; Xing Yu; Yang Xiong; Yongdong Yang; Fengxian Wang; He Zhao
Journal:  J Orthop Surg Res       Date:  2022-03-09       Impact factor: 2.359

8.  Cervical disc prostheses need a variable center of rotation for flexion / extension below disc level, plus a separate COR for lateral bending above disc level to more closely replicate in-vivo motion: MRI-based biomechanical in-vivo study.

Authors:  Manfred K Muhlbauer; Ernst Tomasch; Wolfgang Sinz; Siegfried Trattnig; Hermann Steffan
Journal:  BMC Musculoskelet Disord       Date:  2022-03-08       Impact factor: 2.362

  8 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.