Anatomic referencing of cup orientation in total hip arthroplasty.

UNLABELLED: Pelvic tilt and rotation can drastically affect the apparent cup orientation on conventional anteroposterior pelvic radiographs. It was hypothesized that nonstandardized radiographic cup version and abduction can differ significantly from the corresponding anatomic angles if not measured to the anterior pelvic plane, defined by the pubic tubercles and the anterior superior iliac spine. Differences in preoperative and postoperative pelvic orientation and their influence on radiographic measurements of the two angles were analyzed. Conventional radiographs and preoperative and postoperative computed tomography scans of 37 total hip arthroplasties were compared. Calculations were made with the preoperative planning station of a computer navigation system. Significantly smaller values of cup version were seen on nonstandardized radiographs, whereas abduction could be measured reliably when referenced to horizontal pelvic landmarks seen on radiographs. The underlying cause for this difference was the variation of pelvic tilt that ranged 27 degrees (range, -7 degrees -20 degrees). Influence of pelvic tilt on the apparent cup orientation can be seen with simple nomograms. The orientation of the anterior pelvic plane before and after surgery did not differ. We think that version measurement on nonstandardized radiographs without anatomic referencing is highly inaccurate. LEVEL OF EVIDENCE: Diagnostic study, Level II-1 (development of diagnostic criteria on basis of consecutive patients--with universally applied reference "gold" standard). See Guidelines for Authors for a complete description of levels of evidence.