AIM: Today, cranioplasty is performed using different procedures. Numerous materials may be used to reconstruct the cranial vault including autologous bone and different types of synthetic resins. When plastic materials are used, the main requirement for an effective cranioplasty is the preoperative shaping of the implant to fit the bony defect precisely. In this paper, experience with a new method for cranioplasty using an acrylic cranial implant is presented. MATERIAL AND METHODS: In this new technical procedure an acrylic implant, precisely shaped to the defect, is fabricated preoperatively using CT data. The study consists of 15 cases in whom cranioplasty was performed using this method. In all these, reconstruction was at least 3 months after the initial operation that lead to the cranial bony defect. RESULTS: No major complications occurred and the final functional and aesthetic results were good in all cases. The acrylic implant manufacture does not require the use of complex computer interface software or high-tech equipment, but involves simple, cheap, repeatable processes.
AIM: Today, cranioplasty is performed using different procedures. Numerous materials may be used to reconstruct the cranial vault including autologous bone and different types of synthetic resins. When plastic materials are used, the main requirement for an effective cranioplasty is the preoperative shaping of the implant to fit the bony defect precisely. In this paper, experience with a new method for cranioplasty using an acrylic cranial implant is presented. MATERIAL AND METHODS: In this new technical procedure an acrylic implant, precisely shaped to the defect, is fabricated preoperatively using CT data. The study consists of 15 cases in whom cranioplasty was performed using this method. In all these, reconstruction was at least 3 months after the initial operation that lead to the cranial bony defect. RESULTS: No major complications occurred and the final functional and aesthetic results were good in all cases. The acrylic implant manufacture does not require the use of complex computer interface software or high-tech equipment, but involves simple, cheap, repeatable processes.
Authors: James D Kretlow; Meng Shi; Simon Young; Patrick P Spicer; Nagi Demian; John A Jansen; Mark E Wong; F Kurtis Kasper; Antonios G Mikos Journal: Tissue Eng Part C Methods Date: 2010-06-04 Impact factor: 3.056
Authors: Patrick P Spicer; James D Kretlow; Allan M Henslee; Meng Shi; Simon Young; Nagi Demian; John A Jansen; Mark E Wong; Antonios G Mikos; F Kurtis Kasper Journal: J Biomed Mater Res A Date: 2012-01-12 Impact factor: 4.396
Authors: Roberto De Santis; Veronica Ambrogi; Cosimo Carfagna; Luigi Ambrosio; Luigi Nicolais Journal: J Mater Sci Mater Med Date: 2006-12 Impact factor: 3.896