Literature DB >> 9355007

Kinematics of posterior cruciate ligament-retaining and -sacrificing mobile bearing total knee arthroplasties. An in vitro comparison of the New Jersey LCS meniscal bearing and rotating platform prostheses.

P J Lewandowski1, M J Askew, D F Lin, F W Hurst, A Melby.   

Abstract

The posterior cruciate ligament (PCL)-retaining, meniscal bearing and the PCL-sacrificing rotating platform designs of the LCS prosthesis (DePuy, Warsaw, IN) were designed to minimally constrain knee kinematics while minimizing bone-cement-prosthesis interface stresses and polyethylene wear. The kinematics and stability of the knee following arthroplasty with these devices rely on adequate tensioning of the remaining soft tissues by management of the flexion/extension gaps at the time of surgery. In this in vitro study, the knee kinematics of the function of the quadriceps mechanism for 8 cadaveric knees were measured quantitatively before and after implantation of these 2 prosthesis designs. Following implantation of the PCL-retaining, meniscal bearing prosthesis, anterior translations during anterior drawer testing were significantly greater (P < .05) than those seen in the intact knee. Implantation of the PCL-retaining, meniscal bearing prosthesis resulted in an increase in the extension gap of 2 mm. Quadriceps force needed to achieve full extension was increased by 30% over that needed in the intact knee. The PCL-sacrificing, rotating platform prosthesis constrained anterior translation such that nearly normal anterior knee stability was reestablished; however, the extension gap was increased by 4 mm and the quadriceps force needed to achieve full extension was 50% greater than that needed in the intact knee. Attempts to achieve joint stability by increases in the thickness of the tibial component to widen the flexion/extension gaps results in compromises of quadriceps efficiency, particularly in the absence of a functioning PCL, as demonstrated in this in vitro model. Patients receiving the PCL-sacrificing prosthesis may experience difficulty in those activities requiring quadriceps power near full extension, such as rising from a chair or ascending or descending stairs.

Entities:  

Mesh:

Year:  1997        PMID: 9355007     DOI: 10.1016/s0883-5403(97)90008-5

Source DB:  PubMed          Journal:  J Arthroplasty        ISSN: 0883-5403            Impact factor:   4.757


  12 in total

1.  In vitro investigation of the influence of tibial slope on quadriceps extension force after total knee arthroplasty.

Authors:  Sven Ostermeier; Christof Hurschler; Henning Windhagen; Christina Stukenborg-Colsman
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2006-04-21       Impact factor: 4.342

2.  Femoro-tibial kinematics after TKA in fixed- and mobile-bearing knees in the sagittal plane.

Authors:  Kiriakos Daniilidis; Steffen Höll; Georg Gosheger; Ralf Dieckmann; Nicolo Martinelli; Sven Ostermeier; Carsten O Tibesku
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2012-04-04       Impact factor: 4.342

3.  Functional performance with a single-radius femoral design total knee arthroplasty.

Authors:  Enrique Gómez-Barrena; Carmelo Fernandez-García; Almudena Fernandez-Bravo; Raquel Cutillas-Ruiz; Gloria Bermejo-Fernandez
Journal:  Clin Orthop Relat Res       Date:  2010-05       Impact factor: 4.176

4.  Insall-Salvati ratio stabilizes one year after mobile-bearing total knee arthroplasty and does not correlate with mid-to-long-term clinical outcomes.

Authors:  Yoshinori Ishii; Hideo Noguchi; Junko Sato; Hana Ishii; Nobukazu Ezawa; Shin-Ichi Toyabe
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2018-10-13       Impact factor: 4.342

5.  Clinical relevance of active straight leg raising, standing up, and walking after total knee arthroplasty in a cross-sectional study.

Authors:  Yoshinori Ishii; Hideo Noguchi; Junko Sato; Hana Ishii; Takeshi Yamamoto; Tetsuya Sakurai; Shin-Ichi Toyabe
Journal:  Eur J Orthop Surg Traumatol       Date:  2017-12-05

6.  Are contemporary femoral components sizing and design likely to affect functional results in TKA? A mathematical model of an implanted knee to predict knee forces.

Authors:  A Tecame; M Ferrari; B Violante; G Calafiore; R Papalia; P Adravanti
Journal:  Musculoskelet Surg       Date:  2018-02-05

7.  [A new total knee arthroplasty with physiologically shaped surfaces. Part 2: First clinical results].

Authors:  K-H Frosch; H Nägerl; D Kubein-Meesenburg; J Buchholz; J Dörner; H Dathe; O Hellerer; C Dumont; K M Stürmer
Journal:  Unfallchirurg       Date:  2009-02       Impact factor: 1.000

8.  Quadriceps strength impairment in the mid- to long-term follow-up period after total knee arthroplasty.

Authors:  Yoshinori Ishii; Hideo Noguchi; Junko Sato; Tetsuya Sakurai; Shin-Ichi Toyabe
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2016-09-20       Impact factor: 4.342

9.  Patellar tendon length during knee flexion of meniscal-bearing and rotating total knee arthroplasty implants.

Authors:  Yoshinori Ishii; Hideo Noguchi; Junko Sato; Shota Watanuki; Shin-Ichi Toyabe
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2016-08-12       Impact factor: 4.342

10.  Quadriceps force after TKA with femoral single radius.

Authors:  Sven Ostermeier; Christina Stukenborg-Colsman
Journal:  Acta Orthop       Date:  2011-04-19       Impact factor: 3.717

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.