Literature DB >> 8666447

The influence of titanium abutment surface roughness on plaque accumulation and gingivitis: short-term observations.

M Quirynen1, C M Bollen, W Papaioannou, J Van Eldere, D van Steenberghe.   

Abstract

The roughness of intraoral hard surfaces plays an important role in bacterial adhesion and colonization. Earlier studies have shown that rough surfaces accumulate up to 25 times more subgingival plaque than do smooth sites. In the present study, the influence of surface smoothing was studied. In six partially edentulous patients waiting for a fixed prosthesis supported by endosseous titanium implants, four titanium abutments with different surface roughness were randomly placed. After 1 month of intraoral exposure, subgingival plaque samples from each abutment were compared within each patient by means of differential phase-contrast microscopy. After 3 months, supragingival and subgingival plaque samples were taken from all abutments for differential phase-contrast microscopy and culturing. Probing depth, recession, and bleeding upon probing were scored at the same visit. Differential phase-contrast microscopy showed that subgingivally, only the two roughest abutments harbored spirochetes after 1 month. After 3 months, subgingivally, the composition of the flora showed little variation on the different abutment types, although spirochetes were only noticed around the roughest abutments. Anaerobic culturing resulted in comparable amounts of colony-forming units for all abutment types, both supragingivally and subgingivally. Subgingivally, the microbiologic composition did not show major interabutment differences. Clinically, small differences in probing depth were observed. The roughest abutment showed some attachment gain (0.2 mm) during 3 months, whereas all other abutments had an attachment loss ranging from 0.8 to greater than 1 mm. The results indicate that a reduction in surface roughness (less than a roughness of 0.2 micron) had no major effect on the microbiologic composition, supragingivally or subgingivally. These observations indicate the existence of a threshold roughness below which no further impact on the bacterial adhesion and/or colonization should be expected. However, clinical evaluation seems to indicate that a certain surface roughness is necessary for increased resistance to clinical probing.

Entities:  

Mesh:

Substances:

Year:  1996        PMID: 8666447

Source DB:  PubMed          Journal:  Int J Oral Maxillofac Implants        ISSN: 0882-2786            Impact factor:   2.804


  57 in total

1.  Biomimetic coatings functionalized with adhesion peptides for dental implants.

Authors:  S Roessler; R Born; D Scharnweber; H Worch; A Sewing; M Dard
Journal:  J Mater Sci Mater Med       Date:  2001 Oct-Dec       Impact factor: 3.896

2.  The effects of polishing methods on surface morphology, roughness and bacterial colonisation of titanium abutments.

Authors:  Michele E Barbour; Dominic J O'Sullivan; Howard F Jenkinson; Daryll C Jagger
Journal:  J Mater Sci Mater Med       Date:  2007-03-27       Impact factor: 3.896

3.  Influence of topography and hydrophilicity on initial oral biofilm formation on microstructured titanium surfaces in vitro.

Authors:  A Almaguer-Flores; R Olivares-Navarrete; M Wieland; L A Ximénez-Fyvie; Z Schwartz; B D Boyan
Journal:  Clin Oral Implants Res       Date:  2011-04-15       Impact factor: 5.977

4.  Surface roughness and wear behavior of occlusal splint materials made of contemporary and high-performance polymers.

Authors:  Merve Benli; Beril Eker Gümüş; Yusuf Kahraman; Bilge Gökçen-Rohlig; Gülümser Evlioğlu; Olivier Huck; Mutlu Özcan
Journal:  Odontology       Date:  2019-10-14       Impact factor: 2.634

Review 5.  WITHDRAWN: Interventions for replacing missing teeth: partially absent dentition.

Authors:  Elliot Abt; Alan B Carr; Helen V Worthington
Journal:  Cochrane Database Syst Rev       Date:  2019-07-17

6.  The influence of toothbrushing and coffee staining on different composite surface coatings.

Authors:  Brigitte Zimmerli; Tamara Koch; Simon Flury; Adrian Lussi
Journal:  Clin Oral Investig       Date:  2011-02-18       Impact factor: 3.573

7.  The effect of mechanical and chemical polishing techniques on the surface roughness of heat-polymerized and visible light-polymerized acrylic denture base resins.

Authors:  Abdul Aziz Abdullah Al-Kheraif
Journal:  Saudi Dent J       Date:  2014-02-03

8.  Evaluation of the Effects of Er,Cr:YSGG Laser, Ultrasonic Scaler and Curette on Root Surface Profile Using Surface Analyser and Scanning Electron Microscope: An In Vitro Study.

Authors:  Shipra Arora; Arundeep Kaur Lamba; Farrukh Faraz; Shruti Tandon; Abdul Ahad
Journal:  J Lasers Med Sci       Date:  2016-10-27

9.  Effects of sample preparation on bacterial colonization of polymers.

Authors:  Diana N Zeiger; Christopher M Stafford; Yajun Cheng; Stefan D Leigh; Sheng Lin-Gibson; Nancy J Lin
Journal:  Langmuir       Date:  2010-02-16       Impact factor: 3.882

10.  In vitro adhesion of Streptococcus sanguinis to dentine root surface after treatment with Er:YAG laser, ultrasonic system, or manual curette.

Authors:  Claudia Ota-Tsuzuki; Fernanda L Martins; Ana Paula O Giorgetti; Patrícia M de Freitas; Poliana M Duarte
Journal:  Photomed Laser Surg       Date:  2009-10       Impact factor: 2.796

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.