Efficacy of Microplates versus Miniplates in the Management of Maxillofacial Fractures.

INTRODUCTION: Increased facial trauma has led to advances in techniques of internal fixation, improvements in plating system, refinements in exposure of facial skeleton fueling the rapid use of internal fixation for the management of facial fractures. Evaluating 40 patients with confirmed midfacial (Le Fort I and II) and mandibular fractures, this study presents the efficacy of microplate in comparison with miniplate in terms of load bearing capacity, stability at the fracture site and postoperative palpability.
OBJECTIVES: To evaluate the efficacy of microplates in comparison with miniplates in maxillofacial trauma.
MATERIALS AND METHODS: Study sample consists 40 subjects, 20 each in two groups clinically and radiographically diagnosed with Group 1 (maxillary) and Group 2 (mandibular fractures) which were subdivided into 10 each treated with miniplate and microplate respectively. Postoperatively, stability of fracture, bite force, need for postop MMF, pain, infection, wound dehiscence, mouth opening, occlusion and palpability was noted. All cases have been evaluated clinically for various parameters for minimum of 3 months to assess any postoperative complications.
RESULTS: We found microplates are stable enough and have adequate load bearing capacity. Due to close adaptability and less hardware, postoperative palpability is less but larger sample study with long term follow up is necessary to conclude its efficacy in load bearing fracture sites. Copyright:

INTRODUCTION

The strenuous pace of modern life with high speed travel and increasingly violent society has made facial trauma, a form of social disease from which no one is immune.[1] The prevalence of maxillofacial injuries varies from 17% to 69%, and this large difference might be due to various environmental factors, socioeconomic conditions, cultural reasons, and traffic rules.[23] About 1.25 million people die each year as a result of road traffic accidents (RTAs)[456] out of which the frequency of all-terrain vehicle collisions and motor cycle accidents constitute about 32% with 8% of maxillofacial injuries, mean age being 31 years with more male victims over female.[78]

Maxillomandibular fixation is still the primary mode of immobilization while open and closed reduction depends on the site of the fracture.[9] Nonrigid fixation allows interfragmentary movement across the fracture line and includes techniques such as intraosseous wiring, interdental bridal wiring and interdental bridal wiring for stabilization though it can also result in malunion or nonunion on occasion.[10] Rigid fixation helps to overcome these flaws by preventing interfragmentary distancing under active load. This includes reconstruction plates, bone plates, lag screws, compression plate, and arch bar across a fracture.[11] The goal of compression plating systems described by AO, was establishing absolute stability across a fracture, where traction perpendicular to the fracture was applied by the plate itself.[12] Then, Champy et al. developed the technique of Michelet et al. to describe a method of monocortical, small-plate osteosynthesis utilizing malleable plates inserted intraorally.[1314] Luhr developed the microfixation system revolutionizing the operative management of maxillofacial fractures (MFFs).[15] It was designed with an intention to reduce the bone plate ratio and minimize the hardware to facilitate close adaptation at the fracture site.[1416] The use of microplates is considered meaningful shift in the practice as it is less traumatic to soft-tissue causing minimum tissue interference, resistance to corrosion, special design of connecting bars between the plate holes serves proper contouring that provides 3-dimensional geometric stability, patient comfort on the basis of palpation and thermal conduction due to the thin cutaneous cover.[1718192021] Microplates are used for internal fixation of MFFs as they require less manipulation and are associated with lower likelihood of iatrogenic damage than miniplates that justifies the ability to maintain anatomic apposition of the bone segments, which translates into functional and aesthetic results jeopardizing the fracture stability and the cost of system.[222324]

Hence, we decided to conduct a clinical prospective study to evaluate the efficacy of microplates over miniplate osteosynthesis in terms of occlusal stability, stability of the fracture involved along with the postoperative biting efficiency using bite force device.

Aim and objectives

This study aims to evaluate the efficacy of microplates over miniplates in the management of maxillofacial trauma in terms of stability the fracture site and load bearing capacity with the help of bite force device.

MATERIALS AND METHODS

Study sample collection

The study sample consists of 40 patients above the age of 16 years [Tables 1 and 2] reporting to the Department of Oral and Maxillofacial Surgery, at a teaching dental hospital with confirmed clinically and radiographically diagnosed midfacial or mandibular fractures. Written informed consent was taken from all patients. Ethical clearance was taken from institutional ethical board.

Table 1

Site of maxillary fracture

	Males	Females
Group 1A
Lefort 1	5	2
Lefort 2	2	1
Total	10
Group 1B
Lefort 1	6	1
Lefort 2	3	0
Total	10

Table 2

Site of mandibular fracture

	Males	Females
Group 2A
Coronoid	0	0
Condylar	1	0
Ramus	1	0
Angle	2	0
Body	2	1
Alveolar process	0	0
Symphysis	2	1
Total	10
Group 2B
Coronoid	0	0
Condylar	1	0
Ramus	1	0
Angle	2	1
Body	2	1
Alveolar process	0	0
Symphysis	1	1
Total	10

Inclusive criteria

Patients of above 16 years to 60 years

Patients of both sexes

Patients with confirmed clinical and radiographic diagnosis of Maxillary-Le Fort I, II fractures/mandibular – any one fracture

Dentate patient.

Exclusion criteria

Patients who refused to sign consent form

Comminuted fracture

ASA III and IV

Any maxillary or mandibular fracture undisplaced/fracture not involving occlusion

Combination of any maxilla and mandibular fracture.

Patient we evaluated on following parameters

Pain-Visual Analog Scale

Occlusion-intercuspation of molars and canine

Bite force efficacy – Gnatho dynamometer (Axpert-An ISO 9001)

Facial symmetry

Infection

Plate exposure

Mouth opening

Hardware palpability

Swelling

Need for postoperative maxillomandibular fixation (MMF)

Radiographic assessment.

All patients have been evaluated at 1st and 3rd postoperative month.

Radiographic assessment – Reduction of fracture fragment assessed using score between 1 and 3

1-precise anatomic reduction

2-slightly displaced but satisfactory occlusion

3-poorly reduced that requires second surgery

Bite force device [Figure 1] – The bite force will be recorded using bite fork at anterior and posterior teeth.

Figure 1

Bite Force Device (Axpert-An ISO 9001)

Surgical procedure

Under general anesthesia with oral or nasal intubation, after standard painting and draping, local anesthesia was infused at the fracture site. Incision was placed accordingly and full thickness flap was raised retracting the tissues and neurovasculature. At times, cautery was used during dissection to achieve a bloodless field. The fracture was exposed and reduction was done in the maxilla and/or mandible. Adequate exposure of the fracture segments was obtained. Anatomical reduction was done. Fixation was done with stainless steel miniplates and microplates according to the location with varying screw diameters and lengths. The area was irrigated with betadine and saline. Wound was closed using 3-0 silk or vicryl or in layers where 5-0 prolene was used.

Statistical analysis (subsection)

“Data were expressed as percentage, mean and standard deviation. Statistical significance level was defined at P = 0.05.”

RESULTS

A total of 40 patients were evaluated. Distribution was on the basis of the type of maxillary and mandibular fracture [Tables 1 and 2], treated with mini/microplate. Group 1A-Maxilla (Miniplate), Group 1B-Maxilla (Microplate), Group 2A-Mandible-(Miniplate), Group 2B-(Microplate). Statistically significant values in terms of palpability [Figures 2 and 3] were found in Group 1B-Maxilla (Microplate) and Group 2B-Mandible (microplate). When load bearing capacity [Figures 4 and 5] was measured with bite force device [Figure 1] three months postoperatively in all groups, it was insignificant in the first month for microplate groups, which was less compared to the miniplate groups due to occlusal selfadjustability.

Figure 2

Comparison of presence or absence of palpability among patients treated with mandible microplates/mini-plates

Figure 3

Comparison of presence or absence of palpability among patients treated with maxilla microplates/mini-plates

Figure 4

Comparison of biting force among patients treated with different treated by mandible microplate/miniplate

Figure 5

Comparison of biting force among patients treated with different treated by maxilla microplate/miniplate

DISCUSSION

Maxillofacial trauma has remained a menace in the health-care industry, contributing significant workloads in many maxillofacial units and stretching meager human and material resources.[25262728] Collected data by the World Health Organization from different countries such as India, Japan, the United Arab Emirates, Pakistan, Turkey, and Brazil show that 36%–75% of MFFs were related to RTA.[293031] AO-ASIF guidelines of rigid fixation follow four basic principles ensuring adequate treatment of fractures: bony segment reduction, stable fixation and immobilization of fragments, maintaining blood supply, and early function.[32333435] First presented in Atlanta in November 1987, Hans Luhr defined clinical indications for the use of microplating systems, including nasoethmoidal fractures, infraorbital fractures, frontal sinus fractures, and calvarium reconstruction.[1436]

We performed a study in 40 patients dividing them into two main groups treated with miniplate and microplate in maxillary and mandible emphasizing on the load bearing capacity with biting force device and other parameters such as pain, facial asymmetry, occlusion, wound dehiscence, need for postoperative MMF, and mouth opening. Follow-up was carried out till 3 months. In our study, pain persisted for both groups, maxilla and mandible, treated with miniplate and microplate which was same till the 1st week and gradually decreased till the end of the 3rd month postoperatively. No statistically significant difference was found among these groups. Similarly, Schortinghuis et al.[37] and Lee et al.[38] found no significant difference in pain in their studies treated with mini and microplate.

On comparing facial asymmetry, no significant difference was found except for one patient treated with miniplate in maxilla that presented swelling till first week which gradually subsided. Al Sayed,[39] Ozkan and Cil[40] found no instances of facial asymmetry, malar asymmetry or diplopia.

We found no significant values for infection except for two patients treated with miniplate in maxilla which was managed by antibiotic coverage and periodic irrigation.

Occlusal discrepancy among the groups presented no significant values except for two patients treated with microplate which was managed by IMF for 3–4 weeks' postoperatively. Sadove and Eppley,[41] Gupta et al.,[42] Xie et al.,[43] Huston and Stassen (2016)[44] Anand et al., Abdullah (2009), Ozkan and Cil, Anand et al.[45] found no significant difference among their study groups for fractures treated with microplates in terms of infection and plate exposure. Burm et al. (2002),[46] Jack (2005),[47] Abdullah WA (2009),[48] Ahmed et al.,[49] Joon and Burm[50] reported no significant difference for occlusal discrepancy between both the groups treated with miniplate and microplate. They concluded that the use of microplates is acceptable due to their property of selfadjustability of occlusion.

Plate extrusion was seen in two patients, one in infraorbital and other in mandibular angle, both treated with miniplate which was managed by plate removal, antibiotic coverage, planning of second surgery using microplate and MMF, respectively. No statistically significant results were found for wound dehiscence, need for postoperative MMF and mouth opening among the groups, except for 1 patient with mandibular fracture treated with miniplate where wound dehiscence was noticed which was managed by irrigation and resuturing. Haug and Morgan,[51] Lee et al., Abdullah (2009), Ahmed et al. also concluded that wound dehiscence for microplates is less than miniplates. Haug and Morgan[52] found no occlusal discrepancies during follow-ups using microplates for mandibular angle fracture which was also treated for 6 weeks of IMF for microadaptation. Cawood 1985 and Xie et al. noted more mouth opening in condylar fractures and other mandibular fractures respectively treated with microplate than those treated with miniplates.

In our study, we found significant values for palpability in fractures of maxilla and mandible treated with microplate than miniplate. Sadove and Eppley Lee et al., Schortinghuis et al. also concluded that microplates provide less palpability due to close adaptability at the fracture site.

Mccleod (1992), Xie et al. advocated that microplates facilitate small incisions, resulting in reduced risk of nerve damage. Load bearing capacity of miniplates in mandibular fractures are comparatively more than that of microplates but maxillary fractures treated with microplates shows relatively adequate biting efficiency which was measured by jaw biting force device postoperatively during follow-up till 3rd month. Few weeks postoperatively, load bearing capacity of microplates was found to be less than that of miniplates but after 3 months, positive correlation was found between the values that presented statistically insignificant values in terms of load bearing among the groups. Tate et al.[52] found similar values of load bearing among fractures treated with mini and microplate 3 months' postoperatively which is because of the mechanism of muscle splinting at the time of fracture where selective components of the neuromuscular system activates and deactivates to take forces of the damaged bone. Bite force is related to different factors such as tactile impulses, pain and pressure reception in periodontal ligament, number of residual teeth, and visible decrease in bite force with age owing to age dependent deterioration of dentition. Feller et al.[53] concluded that masticatory load exceeding 200N on the plates occurs only 3 months after osteosynthesis. Cawood[54] found normal weight was restored by the test group in 4 weeks and was more than that to the control group where direct fixation with miniaturized plates was not done.

We found the use of microplates [Figures 6 and 7] can be considered in the management of facial fractures indicating minimum use of hardware, less bone plate ratio, fracture stability, less wound dehiscence, and adequate strength at the fracture site.

Figure 6

Open reduction and internal fixation maxilla (microplate)

Figure 7

Open reduction and internal fixation mandible (microplate)

CONCLUSION

Various plating systems are long drawn in the management of facial trauma complementing the goals of reconstruction and functional stability. Designs of these systems depended on the material and adaptability as handling properties, strength and force distribution as functional outcomes. We found microplates cannot withstand load in unfavorable mandibular fractures thus limiting its use in load bearing areas. However, our study forms a basis for using microplates in facial fractures though we recommend for a larger sample sized study with long-term follow-up that determines the use of microplate for fixation in MFFs.

Financial support and sponsorship

Nil.

Conflicts of interest

There are no conflicts of interest.