Literature DB >> 10376722

Mechanical behavior of human trabecular bone after overloading.

T M Keaveny1, E F Wachtel, D L Kopperdahl.   

Abstract

With the etiology of osteoporotic fractures as motivation, the goal of this study was to characterize the mechanical behavior of human trabecular bone after overloading. Specifically, we quantified the reductions in modulus and strength and the development of residual deformations and determined the dependence of these parameters on the applied strain and apparent density. Forty cylindrical specimens of human L1 vertebral trabecular bone were destructively loaded in compression at 0.5% strain per second to strains of up to 3.0% and then immediately unloaded to zero stress and reloaded. (An ancillary experiment on more readily available bovine bone had been performed previously to develop this testing protocol.) In general, the reloading stress-strain curve had a short initial nonlinear region with a tangent modulus similar to Young's modulus. This was followed by an approximately linear region spanning to 0.7% strain, with a reduced residual modulus. The reloading curve always approached the extrapolated envelope of the original loading curve. Percent modulus reduction (between Young's and residual), a quantitative measure of mechanical damage, ranged from 5.2 to 91.0% across the specimens. It increased with increasing plastic strain (r2 = 0.97) but was not related to modulus or apparent density. Percent strength reduction, in the range of 3.6-63.8%, increased with increasing plastic strain (r2 = 0.61) and decreasing apparent density (r2 = 0.23). The residual strains of up to 1.05% depended strongly on applied strain (r2 = 0.96). Statistical comparisons with previous data for bovine tibial bone lend substantial generality to these trends and provide an envelope of expected behavior for other sites. In addition to providing a basis for biomechanical analysis of the effects of damage in trabecular bone at the organ level, these findings support the concept that occasional overloads may increase the risk of fracture by substantially degrading the mechanical properties of the underlying trabecular bone.

Entities:  

Mesh:

Year:  1999        PMID: 10376722     DOI: 10.1002/jor.1100170308

Source DB:  PubMed          Journal:  J Orthop Res        ISSN: 0736-0266            Impact factor:   3.494


  29 in total

1.  Moderate joint loading reduces degenerative actions of matrix metalloproteinases in the articular cartilage of mouse ulnae.

Authors:  Hui B Sun; Liming Zhao; Shigeo Tanaka; Hiroki Yokota
Journal:  Connect Tissue Res       Date:  2011-12-07       Impact factor: 3.417

Review 2.  Biomechanics and mechanobiology of trabecular bone: a review.

Authors:  Ramin Oftadeh; Miguel Perez-Viloria; Juan C Villa-Camacho; Ashkan Vaziri; Ara Nazarian
Journal:  J Biomech Eng       Date:  2015-01       Impact factor: 2.097

3.  Mechanical failure begins preferentially near resorption cavities in human vertebral cancellous bone under compression.

Authors:  C R Slyfield; E V Tkachenko; S E Fischer; K M Ehlert; I H Yi; M G Jekir; R G O'Brien; T M Keaveny; C J Hernandez
Journal:  Bone       Date:  2012-03-09       Impact factor: 4.398

4.  Potential of in vivo MRI-based nonlinear finite-element analysis for the assessment of trabecular bone post-yield properties.

Authors:  Ning Zhang; Jeremy F Magland; Chamith S Rajapakse; Yusuf A Bhagat; Felix W Wehrli
Journal:  Med Phys       Date:  2013-05       Impact factor: 4.071

5.  Shear strength and toughness of trabecular bone are more sensitive to density than damage.

Authors:  Jacqueline G Garrison; Joshua A Gargac; Glen L Niebur
Journal:  J Biomech       Date:  2011-09-25       Impact factor: 2.712

6.  Material heterogeneity in cancellous bone promotes deformation recovery after mechanical failure.

Authors:  Ashley M Torres; Jonathan B Matheny; Tony M Keaveny; David Taylor; Clare M Rimnac; Christopher J Hernandez
Journal:  Proc Natl Acad Sci U S A       Date:  2016-02-29       Impact factor: 11.205

7.  Quantitative relationships between microdamage and cancellous bone strength and stiffness.

Authors:  C J Hernandez; F M Lambers; J Widjaja; C Chapa; C M Rimnac
Journal:  Bone       Date:  2014-06-11       Impact factor: 4.398

8.  Mechanical properties of morcellised bone graft with the addition of hydroxyapatite.

Authors:  I McNamara; J Howard; A Rayment; R Schalk; R Brooks; S Best; N Rushton
Journal:  J Mater Sci Mater Med       Date:  2014-01-05       Impact factor: 3.896

9.  Density and architecture have greater effects on the toughness of trabecular bone than damage.

Authors:  Jacqueline G Garrison; Constance L Slaboch; Glen L Niebur
Journal:  Bone       Date:  2009-01-14       Impact factor: 4.398

Review 10.  Osteoporosis drug effects on cortical and trabecular bone microstructure: a review of HR-pQCT analyses.

Authors:  Eric Lespessailles; Ridha Hambli; Serge Ferrari
Journal:  Bonekey Rep       Date:  2016-08-31
View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.