Factors affecting tactile spatial acuity.

Tactile spatial acuity on the fingerpad was measured using a grating orientation task. In this task, subjects are required to identify the orientation of square-wave gratings placed on the skin. Previous studies have shown that performance varies as a function of the width of the grooves in the gratings. In the present study, both groove width and the overall size and configuration of the contactors were varied. Sensitivity improved with wider grooves and with larger contactors. Additional measurements showed that the improved sensitivity is not the result of the increase in total area contacted, but rather is due to two other factors associated with larger contactors. One is the greater linear extent of the larger contactors. The other appears to be due to the reduction in the interference produced by the outer edge of the contactor. Specifically, as the contactor increases in size, the distance between the outer edge and the center portion of the grooves also increases. It was also shown that subjects are more sensitive to a single, continuous groove as compared with two grooves of the same total length but spatially discontinuous. Similarly, subjects are more sensitive to a contactor with a continuous groove than to a contactor in which just the end points of the groove are presented. The results are generally consistent with the results of peripheral, neurophysiological recordings. The results are discussed in terms of the way in which both spatial and intensive factors may affect sensitivity to grating orientation.