Colton J Bohonos1,2,3, Shane P Russell1,2,4, David I Morrissey1,2,3,4. 1. University College Cork, Cork, Ireland. 2. Department of Trauma and Orthopaedic Surgery, South Infirmary Victoria University Hospital, Cork, Ireland. 3. Cork University Hospital, Cork, Ireland. 4. Royal College of Surgeons, Dublin, Ireland.
Abstract
INTRODUCTION: Preoperative planning for Reverse Total Shoulder Arthroplasty (RTSA) using CT or MRI is well described.1, 2, 3, 4, 5, 6, 7 We aimed to compare pre-operative CT versus MRI measurement accuracy for predicting intra-operative glenoid implant sizing. METHODS: All patients with a preoperative CT or MRI undergoing RTSA at our tertiary referral center from October 2017 to February 2020 were included. Data was collected from theatre and implant registers. Glenosphere Width (GW) and Baseplate Central Screw Length (BCSL) were independently predicted from pre-operative CT or MRI imaging by 2 blinded senior authors. A sub-group analysis was also performed between trauma and non-trauma CT cases. SPSS v26 was used for statistical comparison between predicted and actual implants. RESULTS: 71 data sets from 69 patients were included for analysis: 31 CT predictions and 40 MRI predictions. 61.3% of CT measured GW predictions were accurate compared to 82.5% of MRI predictions (p = 0.045). BCSL predictions were 77.4% and 70% accurate for CT and MRI respectively, without significant difference. There was no significant difference in sub-group analysis for trauma vs elective CT accuracy of BCSL or GW measurements. CONCLUSION: MRI imaging may be superior to CT for predicting GW and no less accurate than CT for predicting BCSL in the elective setting. No difference in CT measurement accuracy was seen between trauma and elective settings. While simultaneously clearly defining shoulder soft tissue anatomy, MRI may also be the preferred modality for bony measurements during pre-operative planning for elective RTSA.
INTRODUCTION: Preoperative planning for Reverse Total Shoulder Arthroplasty (RTSA) using CT or MRI is well described.1, 2, 3, 4, 5, 6, 7 We aimed to compare pre-operative CT versus MRI measurement accuracy for predicting intra-operative glenoid implant sizing. METHODS: All patients with a preoperative CT or MRI undergoing RTSA at our tertiary referral center from October 2017 to February 2020 were included. Data was collected from theatre and implant registers. Glenosphere Width (GW) and Baseplate Central Screw Length (BCSL) were independently predicted from pre-operative CT or MRI imaging by 2 blinded senior authors. A sub-group analysis was also performed between trauma and non-trauma CT cases. SPSS v26 was used for statistical comparison between predicted and actual implants. RESULTS: 71 data sets from 69 patients were included for analysis: 31 CT predictions and 40 MRI predictions. 61.3% of CT measured GW predictions were accurate compared to 82.5% of MRI predictions (p = 0.045). BCSL predictions were 77.4% and 70% accurate for CT and MRI respectively, without significant difference. There was no significant difference in sub-group analysis for trauma vs elective CT accuracy of BCSL or GW measurements. CONCLUSION: MRI imaging may be superior to CT for predicting GW and no less accurate than CT for predicting BCSL in the elective setting. No difference in CT measurement accuracy was seen between trauma and elective settings. While simultaneously clearly defining shoulder soft tissue anatomy, MRI may also be the preferred modality for bony measurements during pre-operative planning for elective RTSA.
Authors: Ryan W Simovitch; Matthias A Zumstein; Eveline Lohri; Naeder Helmy; Christian Gerber Journal: J Bone Joint Surg Am Date: 2007-03 Impact factor: 5.284
Authors: J Berhouet; L V Gulotta; D M Dines; E Craig; R F Warren; D Choi; X Chen; A Kontaxis Journal: Orthop Traumatol Surg Res Date: 2017-02-24 Impact factor: 2.256
Authors: Joseph Iannotti; Justin Baker; Eric Rodriguez; John Brems; Eric Ricchetti; Mena Mesiha; Jason Bryan Journal: J Bone Joint Surg Am Date: 2014-05-07 Impact factor: 5.284