| Literature DB >> 33395885 |
A A J Grüter1, S E Van Oostendorp1, L J H Smits1, M Kusters1, M Özer2, J A Nieuwenhuijzen3, J B Tuynman4.
Abstract
INTRODUCTION: Iatrogenic recto-urogenital fistulae are refractory complications that rarely heal without surgical intervention. The ongoing local infection causes pain, discomfort and substantially impacts quality of life. Surgical repair requires adequate exposure and space to fill with healthy tissue, which is a major challenge in pelvic redo surgery. An abdominal approach to repair the fistula is associated with major morbidity and often fails to expose the deep pelvis. In our experience a novel transperineal minimally invasive approach a utilizing single incision laparoscopic surgery (SILS) technique could offer improved results. PRESENTATION OF CASES: In the present study, three cases of patients with recto-urogenital fistulae after pelvic surgery are described. Two patients were diagnosed with a rectovesical fistula and one patient with a rectovaginal fistula. In all three cases, a minimally invasive perineal approach, using a SILS port, was used to perform surgical repair. The closure of the fistulae involved: a separate repair of the urethra/bladder or vaginal defect and the rectal defect, followed by interposition of vascularized tissue by either a pudendal thigh fasciocutaneous flap or omentoplasty. DISCUSSION ANDEntities:
Keywords: Case series; Minimally invasive; Perineal redo surgery; Rectovaginal fistula; Rectovesical fistula; SILS
Year: 2020 PMID: 33395885 PMCID: PMC7724097 DOI: 10.1016/j.ijscr.2020.11.067
Source DB: PubMed Journal: Int J Surg Case Rep ISSN: 2210-2612
Fig. 1CT abdomen with intravesical contrast administered via catheter, illustrates a small amount of contrast in the urinary bladder with extraluminal contrast collected in the prostate bed. This indicates a dorsal bladder wall defect, suggesting that there is an open communication between the urinary bladder and surgical bed. The arrow points to the extraluminal contrast. On the left side (transverse section), a defect of the ventral rectal wall is illustrated.
Fig. 4Perineal incision with the pudendal thigh flap.
Fig. 2CT abdomen with intravescial contrast administered via catheter, shows a connection between the urinary bladder and the rectum, illustrating the rectovesical fistula. The arrow points out the rectovesical fistula.
Fig. 3CT scan of the abdomen with rectal contrast shows a rectovaginal fistula. The arrow points to the rectovaginal fistula.
| Step 1: | Identify the fistula tract using a transanal approach using a SILS port. The tract is excised and the rectal wall is separated from the urethra and vesical wall. |
|---|---|
| Step 2: | Closure of the urethral-vesical anastomosis defect with sutures transanally. Alternatively, this can be done transperineally after full dissection of the space between the rectum and bladder. |
| Step 3: | Make a perineal incision and position the SILS port. The minimally invasive perineal approach is used to further dissect the rectal wall from the vesical wall. |
| Step 4: | Create a pudendal thigh fasciocutaneous flap of the left groin. Mobilize the flap, pedicle it on the external pudendal artery and deepithelialized it. After the flap is deepithelialized, insert the pudendal thigh flap into the perineal wound with guidance of the camera to allow optimal placement across the defect of the previous fistula. |
| Step 5: | Position and suture the flap proximally to both rectal and vesical defects. The transanal approach with a SILS port is used to position and suture the flap. |
| Step 6: | The rectal wall is closed with sutures transanally with the use of a SILS port. |
| Step 1: | Laparoscopic mobilization of an omentum in order to facilitate an omentoplasty. |
|---|---|
| Step 2: | Identification of the fistula tract by a transanal approach. Excision of the fistula tract traced and separation of the rectal and vaginal wall. |
| Step 3: | Transperineal access with small incision to create more space distally and proximally of the fistula using a SILS port. |
| Step 4: | Sutured closure of the vaginal wall from transvaginal placement of the port. |
| Step 5: | Bring down the omentoplasty to the perineum bridging the site of the previous fistula tract. Transanal anchoring sutures of the omentoplasty subcutaneously. |
| Step 6: | Transanal full thickness closure of the defect in the rectal wall with the use of a SILS port. |
| Step 7: | Reversed leak test by filling the pelvic cavity from the abdominal site with saline. Insufflation and transanal and transvaginal inspection of the closure sites for air leakage. |