Reliability and Test-Retest Agreement of Mechanical Variables Obtained During Countermovement Jump.

The countermovement jump (CMJ) is often used as performance measure and monitoring tool. Traditionally, jump height (JH) is most often studied and reported, but other variables (e.g. force, velocity, power) can also be obtained during CMJ testing on a force plate. The aim of this study was to determine the intra-rater reliability of mechanical variables obtained during CMJs. For this, 41 physically active men (24 ± 4 years) performed four CMJs on a force plate with an interval of 48 to 168 hours (test-retest design). Six variables were analyzed: 1) jump height (JH), 2) peak force (PF), 3) peak power (PP), 4) velocity at takeoff (VTO), 5) rate of force (RFD) and 6) power (RPD) development. Five variables showed to be reliable (i.e. CV < 10%), except RFD (CV of 12.9%). Although JH exhibited an acceptable level of reliability (r = 0.94 and CV = 5.8%), better scores were observed for PF, VTO, and PP (CV ranging from 2.5 to 5.1%). The PF showed the best reliability scores (r = 0.99 and CV = 2.5%) and RPD, a relatively unexamined variable compared to the others, showed an acceptable level of reliability (r = 0.96 and CV = 7.8%). Therefore, JH, PF, PP, VTO, and RPD demonstrated acceptable scores of reliability. PF seems to be the most appropriate variable to use when small changes in performance are expected. Future studies should investigate the importance of RPD for performance evaluation.