| Literature DB >> 27973589 |
Enrique Maguilla1, Marcial Escudero2.
Abstract
Disappearance of diagnostic morphological characters due to hybridization is considered to be one of the causes of the complex taxonomy of the species-rich (ca. 2000 described species) genus Carex (Cyperaceae). Carex furva s.l. belongs to section Glareosae. It is an endemic species from the high mountains of the Iberian Peninsula (Spain and Portugal). Previous studies suggested the existence of two different, cryptic taxa within C. furva s.l. Intermediate morphologies found in the southern Iberian Peninsula precluded the description of a new taxa. We aimed to determine whether C. furva s.l. should be split into two different species based on the combination of morphological and molecular data. We sampled ten populations across its full range and performed a morphological study based on measurements on herbarium specimens and silica-dried inflorescences. Both morphological and phylogenetic data support the existence of two different species within C. furva s.l. Nevertheless, intermediate morphologies and sterile specimens were found in one of the southern populations (Sierra Nevada) of C. furva s.l., suggesting the presence of hybrid populations in areas where both supposed species coexist. Hybridization between these two putative species has blurred morphological and genetic limits among them in this hybrid zone. We have proved the utility of combining molecular and morphological data to discover a new cryptic species in a scenario of hybridization. We now recognize a new species, C. lucennoiberica, endemic to the Iberian Peninsula (Sierra Nevada, Central system and Cantabrian Mountains). On the other hand, C. furva s.s. is distributed only in Sierra Nevada, where it may be threatened by hybridization with C. lucennoiberica. The restricted distribution of both species and their specific habitat requirements are the main limiting factors for their conservation.Entities:
Mesh:
Year: 2016 PMID: 27973589 PMCID: PMC5156347 DOI: 10.1371/journal.pone.0166949
Source DB: PubMed Journal: PLoS One ISSN: 1932-6203 Impact factor: 3.240
Fig 1Distribution map of C. furva s.s. and C. lucennoiberica based on examined specimens on herbaria collections and field trip records.
Codes indicate sampled populations as follows: C1 = Serra da Estrela; C2 = Sierra de Béjar; C3 = Sierra del Barco; C4 = Picos de Gredos; C5 = Sierra de Guadarrama; N1 = Sierra Segundera; N2 = Sierra del Cornón; N3 = Fuentes Carrionas (Curavacas); S1 (C. furva s.s.) and S2 (hybrid) = Sierra Nevada. Created using country borders from Brummitt et al. [62] and elevation data from CGIAR [63] under a CC BY license, with permission from CGIAR, original copyright 2008.
Morphological variables and descriptions
| Variable | Description (units) |
|---|---|
| CLML | Distance from the base of the culm to the start of the inflorescence (mm) |
| CLML-max | Maximum culm length in a specimen when more than one fertile and mature culm is present (mm) |
| CLML-min | Minimum culm length in a specimen when more than one fertile and mature culm is present (mm) |
| CLMW | Width of the culm in the medial region (mm) |
| CLMW-max | Maximum culm width in a specimen when more than one fertile and mature culm is present (mm) |
| CLMW-min | Minimum culm width in a specimen when more than one fertile and mature culm is present (mm) |
| ILEAFL | Distance from the base to the tip of the inferior leaf (mm) |
| ILEAFW | Width of the inferior leaf in the medial portion (mm) |
| SLEAFL | Distance from the base to the tip of the superior leaf (mm) |
| SLEAFW | Width of the superior leaf in the medial portion (mm) |
| LEAFL-max | Maximum leaf length in a specimen (mm) |
| LEAFL-min | Minimum leaf length in a specimen (mm) |
| LEAFW-max | Maximum leaf width in a specimen (mm) |
| LEAFW-min | Minimum leaf width in a specimen (mm) |
| LIGL | Maximum ligule length (mm) |
| INFL | Distance from the base of the inflorescence to the bottom of the uppermost utricle beak (mm) |
| INFL-max | Maximum inflorescence length in a specimen when more than one fertile and mature culm is present (mm) |
| INFL-min | Minimum inflorescence length in a specimen when more than one fertile and mature culm is present (mm) |
| INFW | Maximum width of the inflorescence in horizontal, from the bases of the utricle beaks (mm) |
| INFW-max | Maximum inflorescence width in a specimen when more than one fertile and mature culm is present (mm) |
| INFW-min | Minimum inflorescence width in a specimen when more than one fertile and mature culm is present (mm) |
| INFL/INFW | Ratio inflorescence length: inflorescence width (mm) |
| SPKN | Number of spikes in the inflorescence (entire number) |
| SPIKL | Distance from the base of the apical spike to the bottom of the uppermost utricle beak (mm) |
| SPIKL-max | Maximum spike length in a specimen (mm) |
| SPIKL-min | Minimum spike length in a specimen (mm) |
| SPIKW | Maximum width of the apical spike excluding utricle beaks (mm) |
| SPIKW-max | Maximum spike width in a specimen (mm) |
| SPIKW-min | Minimum spike width in a specimen (mm) |
| LSPIKA | Angle of the lowermost spike of the inflorescence relative to the culm (degrees) |
| SLSPIKA | Angle of the second lower spike–from the bottom–of the inflorescence relative to the culm (degrees) |
| USPIKA | Angle of the uppermost spike of the inflorescence relative to the culm (degrees) |
| PSCLL | Maximum glume length of the medial point of the spike (mm) |
| PSCLW | Maximum glume width of the medial point of the spike (mm) |
| MAXHYAL | Length of the widest hyaline margin in female glumes (mm) |
| MINHYAL | Length of the narrowest hyaline margin in female glumes (mm) |
| PERL | Maximum length of the utricle from the base, including the beak (mm) |
| PERW | Maximum width of the utricle (mm) |
| PERL/PERW | Ratio utricle length: utricle width |
| PERMWD | Distance from the maximum width to the base of the utricle (mm) |
| PERL/PERMWD | Ratio utricle length: distance from the base to the maximum width distance of the utricle |
| PERBKL | Distance from distal point of the utricle to the distal point of the achene (mm) |
| PERSTL | Distance from the distal point of the utricle beak to the end of the abaxial suture (mm) |
| PERIGTHN | Number of teeth in the utricle beak (entire number) |
| ACHL | Maximum achene length (mm) |
| ACHW | Maximum achene width (mm) |
Fig 2Representation of measured morphological variables in a specimen.
(A) General aspect; (B) ligule; (C) inflorescence; (D) female glume; (E) utricle; (F) achene. Photographs A, B and D correspond to C. furva s.s. and C, E and F to C. lucennoiberica. Meaning of the variables as described in Table 1.
Fig 3Principal Component Analysis (PCA) scatter plot of the first two principal components: A. including hybrid population; B. excluding hybrids. Only selected variables were used (nine when including hybrid populations, and 11 when excluded). Circles represent Carex furva s.s., triangles for C. lucennoiberica, and squares for specimens of the hybrid population. Colors indicate the mountain range where the specimens were collected, where C1 = Serra da Estrela; C2 = Sierra de Béjar; C3 = Sierra del Barco; C4 = Picos de Gredos; C5 = Sierra de Guadarrama; N1 = Sierra Segundera; N2 = Sierra del Cornón; N3 = Fuentes Carrionas (Curavacas); S1 (C. furva s.s.) and S2 (hybrid) = Sierra Nevada.
Fig 4Majority-rule consensus tree from Bayesian inference analysis of the concatenated matrix of nrDNA regions ETS, ITS, G3PDH and cpDNA region matK.
Posterior probabilities (PP, only if higher than 0.9) from the Bayesian analysis and bootstrap values (if > 70%) from the maximum likelihood analysis are shown above and below branches, respectively. Lack of support in only one analysis is represented by asterisks. Tip labels indicate species name. In the case of C. furva s.s. and C. lucennoiberica, we have also included sampling locality. Red square represents the boundaries of C. furva s.l. Scale bar indicates substitutions per site.
Fig 5Botanical illustration of Carex furva Webb.
SPAIN: Granada, Sierra Nevada, Capileira, Sierra Nevada National Park. 08 August 2013. E. Maguilla (31EMS13(15)) & J. M. G. Cobos. UPOS-5132. (A) General aspect; (B) culm base; (C) ligule; (D) leaf appex; (E) inflorescence; (F) male glume; (G) female glume; (H) utricle, abaxial view; (I) utricle, adaxial face; (J) utricle, cross-section; (K) achene.
Fig 6Botanical illustration of Carex lucennoiberica Maguilla & M. Escudero.
Paratype. SPAIN: Madrid, Sierra de Guadarrama, Rascafría, Sierra de Guadarrama Nacional Park. 22 August 2013. E. Maguilla (35EMS13(5)) & T. Villaverde. UPOS-5141. (A) General aspect; (B) culm base; (C) ligule; (D) leaf appex; (E) inflorescence; (F) male glume; (G) female glume; (H) utricle, abaxial view; (I) utricle, adaxial face; (J) utricle, cross-section; (K) achene.
Fig 7Carex lucennoiberica Maguilla & M. Escudero.
Holotype. SPAIN: Ávila, Sierra de Béjar, arroyo Malillo. 07-August-2010. M. Luceño (21ML10), P. Jiménez-Mejías & M. González. UPOS-4319. (A) General aspect; (B) leaf apex; (C) ligule; (D) inflorescence; (E) male glume; (F) female glume; (G) utricle, abaxial view; (H) utricle, adaxial view; (I) achene. Scale bars: A = 1 mm; B = 0.5 mm; C = 1 mm; D = 2 mm; E-I = 0.5 mm.
Diagnosis characters distinguishing C. lucennoiberica from its relative C. furva s.s.
| 2.1–8.6 (10.9) cm | 3.7–23.8 (29.2) cm | |
| Glumaceous | Linear or setaceous, sometimes glumaceous | |
| Usually capitate——aggregated and rounded shape—, with utricle beaks clearly prominent in the outline, dark brown | Ovoid or shortly oblong, rarely capitate, with utricle beaks appressed to the spike, not prominent in the outline, light brown | |
| Much shorter than utricles | As long as or shorter than utricles | |
| (1.94) 2.15–2.66 mm length, faintly veined, erect to erect-spreading, the lower usually spreading | 1.48–2.37 mm length, prominently veined, the lower rarely spreading |