S Agarwal1, F Rosete1, C Zhang1, D J McMahon1, X E Guo2, E Shane1, K K Nishiyama3. 1. Division of Endocrinology, Department of Medicine, Columbia University, New York, NY, USA. 2. Department of Biomedical Engineering, Columbia University, New York, NY, USA. 3. Division of Endocrinology, Department of Medicine, Columbia University, New York, NY, USA. kn2205@columbia.edu.
Abstract
UNLABELLED: Bone strength is dependent on bone density and microstructure. High-resolution peripheral quantitative computed tomography (HR-pQCT) can measure microstructure but is somewhat limited due to its resolution. We compared a new HR-pQCT scanner to existing technology and found very good agreement for most parameters. This study will be important when interpreting results from different devices. INTRODUCTION: Recently, a second-generation HR-pQCT scanner (XCT2) has been developed with a higher nominal isotropic resolution (61 μm) compared to the first-generation device (XCT1, 82 μm). It is unclear how in vivo measurements from these two devices compare. In this study, we obtained and analyzed in vivo XCT1 and XCT2 measurements of bone microarchitecture and estimated strength. METHODS: We scanned 51 adults (16 men and 35 women, age 44.8 ± 16.0) on both XCT2 and XCT1 on the same day. We first compared XCT1 and XCT2 measurements obtained using their respective standard patient protocols. In XCT1, microarchitecture parameters were derived, while XCT2 measurements were directly measured. We also compared XCT2-D with XCT1 by finding the overlapping regions of interest and using the standard patient protocol for XCT1. RESULTS: We obtained excellent agreement between XCT1 and XCT2 for most of the volumetric bone mineral density (vBMD), trabecular and cortical measurements (All R (2) > 0.820) except for cortical porosity at the radius (R (2) = 0.638), trabecular number (R (2) = 0.694, 0.787) and trabecular thickness (R (2) = 0.569, 0.527) at both radius and tibia, respectively. XCT1 and XCT2-D measurements also had excellent agreement for most of the measurements (all R (2) > 0.870) except trabecular number (R (2) = 0.524, 0.706), trabecular thickness (R (2) = 0.758, 0.734) at both radius and tibia, respectively, and trabecular separation (R (2) = 0.656) at the radius. CONCLUSION: While some caution should be exercised for parameters that are more dependent on image resolution, results from our study indicate that second-generation scans can be compared to more widely available first-generation data and may be beneficial for multicenter and longitudinal studies using both scanner generations.
UNLABELLED: Bone strength is dependent on bone density and microstructure. High-resolution peripheral quantitative computed tomography (HR-pQCT) can measure microstructure but is somewhat limited due to its resolution. We compared a new HR-pQCT scanner to existing technology and found very good agreement for most parameters. This study will be important when interpreting results from different devices. INTRODUCTION: Recently, a second-generation HR-pQCT scanner (XCT2) has been developed with a higher nominal isotropic resolution (61 μm) compared to the first-generation device (XCT1, 82 μm). It is unclear how in vivo measurements from these two devices compare. In this study, we obtained and analyzed in vivo XCT1 and XCT2 measurements of bone microarchitecture and estimated strength. METHODS: We scanned 51 adults (16 men and 35 women, age 44.8 ± 16.0) on both XCT2 and XCT1 on the same day. We first compared XCT1 and XCT2 measurements obtained using their respective standard patient protocols. In XCT1, microarchitecture parameters were derived, while XCT2 measurements were directly measured. We also compared XCT2-D with XCT1 by finding the overlapping regions of interest and using the standard patient protocol for XCT1. RESULTS: We obtained excellent agreement between XCT1 and XCT2 for most of the volumetric bone mineral density (vBMD), trabecular and cortical measurements (All R (2) > 0.820) except for cortical porosity at the radius (R (2) = 0.638), trabecular number (R (2) = 0.694, 0.787) and trabecular thickness (R (2) = 0.569, 0.527) at both radius and tibia, respectively. XCT1 and XCT2-D measurements also had excellent agreement for most of the measurements (all R (2) > 0.870) except trabecular number (R (2) = 0.524, 0.706), trabecular thickness (R (2) = 0.758, 0.734) at both radius and tibia, respectively, and trabecular separation (R (2) = 0.656) at the radius. CONCLUSION: While some caution should be exercised for parameters that are more dependent on image resolution, results from our study indicate that second-generation scans can be compared to more widely available first-generation data and may be beneficial for multicenter and longitudinal studies using both scanner generations.
Entities:
Keywords:
Bone microarchitecture; Bone strength; HR-pQCT; High-resolution peripheral quantitative computed tomography
Authors: M Krause; O Museyko; S Breer; B Wulff; C Duckstein; E Vettorazzi; C Glueer; K Püschel; K Engelke; M Amling Journal: Osteoporos Int Date: 2014-02-25 Impact factor: 4.507
Authors: Ego Seeman; Pierre D Delmas; David A Hanley; Deborah Sellmeyer; Angela M Cheung; Elizabeth Shane; Ann Kearns; Thierry Thomas; Steven K Boyd; Stephanie Boutroy; Cesar Bogado; Sharmila Majumdar; Michelle Fan; Cesar Libanati; Jose Zanchetta Journal: J Bone Miner Res Date: 2010-08 Impact factor: 6.741
Authors: D E Whittier; S K Boyd; A J Burghardt; J Paccou; A Ghasem-Zadeh; R Chapurlat; K Engelke; M L Bouxsein Journal: Osteoporos Int Date: 2020-05-26 Impact factor: 4.507
Authors: Hugo J W Fung; Angela M Cheung; Sunita Mathur; Eva Szabo; Andy K O Wong Journal: J Musculoskelet Neuronal Interact Date: 2022-06-01 Impact factor: 1.864
Authors: Jane A Cauley; Andrew J Burghardt; Stephanie L Harrison; Peggy M Cawthon; Ann V Schwartz; Elizabeth Barrett Connor; Kristine E Ensrud; Lisa Langsetmo; Sharmila Majumdar; Eric Orwoll Journal: J Bone Miner Res Date: 2018-06-12 Impact factor: 6.741
Authors: Jessica F Starr; Leonardo C Bandeira; Sanchita Agarwal; Ankit M Shah; Kyle K Nishiyama; Yizhong Hu; Donald J McMahon; X Edward Guo; Shonni J Silverberg; Mishaela R Rubin Journal: J Bone Miner Res Date: 2018-06-15 Impact factor: 6.741
Authors: Han Jo Kim; Alexander Dash; Matthew Cunningham; Frank Schwab; James Dowdell; Jonathan Harrison; Caroline Zaworski; Alexandra Krez; Virginie Lafage; Sanchita Agarwal; Brandon Carlson; Donald J McMahon; Emily M Stein Journal: Bone Date: 2020-11-04 Impact factor: 4.626