Literature DB >> 27044288

Optimization of lipid extraction from Salvinia molesta for biodiesel production using RSM and its FAME analysis.

M Mubarak1, A Shaija2, T V Suchithra3.   

Abstract

The higher areal productivity and lipid content of microalgae and aquatic weed makes them the best alternative feedstocks for biodiesel production. Hence, an efficient and economic method of extracting lipid or oil from aquatic weed, Salvinia molesta is an important step towards biodiesel production. Since Salvinia molesta is an unexplored feedstock, its total lipid content was first measured as 16 % using Bligh and Dyer's method which was quite sufficient for further investigation. For extracting more amount of lipid from Salvinia molesta, methanol: chloroform in the ratio 2:1 v/v was identified as the most suitable solvent system using Soxhlet apparatus. Based on the literature and the preliminary experimentations, parameters such as solvent to biomass ratio, temperature, and time were identified as significant for lipid extraction. These parameters were then optimized using response surface methodology with central composite design, where experiments were performed using twenty combinations of these extraction parameters with Minitab-17 software. A lipid yield of 92.4 % from Salvinia molesta was obtained with Soxhlet apparatus using methanol and chloroform (2:1 v/v) as solvent system, at the optimized conditions of temperature (85 °C), solvent to biomass ratio (20:1), and time (137 min), whereas a predicted lipid yield of 93.5 % with regression model. Fatty acid methyl ester (FAME) analysis of S. molesta lipid using gas chromatograph mass spectroscopy (GCMS) with flame ionization detector showed that fatty acids such as C16:0, C16:1, C18:1, and C18:2 contributed more than 9 % weight of total fatty acids. FAME consisted of 56.32, 28.08, and 15.59 % weight of monounsaturated, saturated, and polyunsaturated fatty acids, respectively. Higher cetane number and superior oxidation stability of S. molesta FAME could be attributed to its higher monounsaturated content and lower polyunsaturated content as compared to biodiesels produced from C. vulgaris, Sunflower, and Jatropha.

Entities:  

Keywords:  Biodiesel; Bligh and Dyer method; Salvinia molesta; Soxhlet apparatus

Mesh:

Substances:

Year:  2016        PMID: 27044288     DOI: 10.1007/s11356-016-6343-8

Source DB:  PubMed          Journal:  Environ Sci Pollut Res Int        ISSN: 0944-1344            Impact factor:   4.223


  11 in total

1.  A rapid method of total lipid extraction and purification.

Authors:  E G BLIGH; W J DYER
Journal:  Can J Biochem Physiol       Date:  1959-08

Review 2.  Extraction of oil from microalgae for biodiesel production: A review.

Authors:  Ronald Halim; Michael K Danquah; Paul A Webley
Journal:  Biotechnol Adv       Date:  2012-01-11       Impact factor: 14.227

3.  Optimizing pressurized liquid extraction of microbial lipids using the response surface method.

Authors:  J Cescut; E Severac; C Molina-Jouve; J-L Uribelarrea
Journal:  J Chromatogr A       Date:  2010-12-10       Impact factor: 4.759

4.  Optimization of media composition for Nattokinase production by Bacillus subtilis using response surface methodology.

Authors:  V Deepak; K Kalishwaralal; S Ramkumarpandian; S Venkatesh Babu; S R Senthilkumar; G Sangiliyandi
Journal:  Bioresour Technol       Date:  2008-04-21       Impact factor: 9.642

5.  Biogas production from water hyacinth and channel grass used for phytoremediation of industrial effluents.

Authors:  V Singhal; J P N Rai
Journal:  Bioresour Technol       Date:  2003-02       Impact factor: 9.642

6.  Oil extraction from Scenedesmus obliquus using a continuous microwave system--design, optimization, and quality characterization.

Authors:  Sundar Balasubramanian; James D Allen; Akanksha Kanitkar; Dorin Boldor
Journal:  Bioresour Technol       Date:  2010-10-08       Impact factor: 9.642

7.  Oil extraction from microalgae for biodiesel production.

Authors:  Ronald Halim; Brendan Gladman; Michael K Danquah; Paul A Webley
Journal:  Bioresour Technol       Date:  2010-07-23       Impact factor: 9.642

8.  Influence of fatty acid composition of raw materials on biodiesel properties.

Authors:  María Jesús Ramos; Carmen María Fernández; Abraham Casas; Lourdes Rodríguez; Angel Pérez
Journal:  Bioresour Technol       Date:  2008-08-09       Impact factor: 9.642

9.  Comparison of several methods for effective lipid extraction from microalgae.

Authors:  Jae-Yon Lee; Chan Yoo; So-Young Jun; Chi-Yong Ahn; Hee-Mock Oh
Journal:  Bioresour Technol       Date:  2009-04-21       Impact factor: 9.642

10.  Bioconversion of water-hyacinth (Eichhornia crassipes) hemicellulose acid hydrolysate to motor fuel ethanol by xylose-fermenting yeast.

Authors:  J N Nigam
Journal:  J Biotechnol       Date:  2002-08-07       Impact factor: 3.307

View more
  2 in total

1.  Multi-objective optimization of diesel engine performance and emissions fueled with diesel-biodiesel-fusel oil blends using response surface method.

Authors:  Amin Hassan Pour; Seyed Mohammad Safieddin Ardebili; Mohammad Javad Sheikhdavoodi
Journal:  Environ Sci Pollut Res Int       Date:  2018-10-22       Impact factor: 4.223

2.  Aquatic Plants, Landoltia punctata, and Azolla filiculoides as Bio-Converters of Wastewater to Biofuel.

Authors:  Ana F Miranda; N Ram Kumar; German Spangenberg; Sanjukta Subudhi; Banwari Lal; Aidyn Mouradov
Journal:  Plants (Basel)       Date:  2020-04-01
  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.