PURPOSE: Minimally invasive surgery is becoming the standard treatment of care for a variety of procedures. Surgeons need to display a high level of proficiency to overcome the challenges imposed by the minimal access. Especially when operating on a dynamic organ, it becomes very difficult to align instruments reliably and precisely. In this paper, a hybrid rigid/continuum robotic system and a dedicated robotic control approach are proposed to assist the surgeon performing complex surgical gestures in a dynamic environment. METHODS: The proposed robotic system consists of a rigid robot arm on top of which a continuum robot is mounted in series. The continuum robot is locally actuated with McKibben muscles. A control scheme based on quadratic programming framework is adopted. It is shown that the framework allows enforcing a set of constraints on the pose of the tip, as well as of the instrument shaft, which is commanded to slide in and out through the entry point. RESULTS: Through simulation and experiments, it is shown how the robot tool tip is able to follow sinusoidal trajectories of 0.37 and 2 Hz, while maintaining the instrument shaft pivoting along the entry point. The positioning and tracking accuracy of such system are shown to lie below 4.7 mm in position and [Formula: see text] in angle. CONCLUSION: The results suggest a good potential for applying the proposed technology to assist the surgeon during complex robot-assisted interventions. It is also illustrated that even when using flexible hence relatively safe end-effectors, it is possible to reach acceptable tracking behaviour at relatively high frequencies.
PURPOSE: Minimally invasive surgery is becoming the standard treatment of care for a variety of procedures. Surgeons need to display a high level of proficiency to overcome the challenges imposed by the minimal access. Especially when operating on a dynamic organ, it becomes very difficult to align instruments reliably and precisely. In this paper, a hybrid rigid/continuum robotic system and a dedicated robotic control approach are proposed to assist the surgeon performing complex surgical gestures in a dynamic environment. METHODS: The proposed robotic system consists of a rigid robot arm on top of which a continuum robot is mounted in series. The continuum robot is locally actuated with McKibben muscles. A control scheme based on quadratic programming framework is adopted. It is shown that the framework allows enforcing a set of constraints on the pose of the tip, as well as of the instrument shaft, which is commanded to slide in and out through the entry point. RESULTS: Through simulation and experiments, it is shown how the robot tool tip is able to follow sinusoidal trajectories of 0.37 and 2 Hz, while maintaining the instrument shaft pivoting along the entry point. The positioning and tracking accuracy of such system are shown to lie below 4.7 mm in position and [Formula: see text] in angle. CONCLUSION: The results suggest a good potential for applying the proposed technology to assist the surgeon during complex robot-assisted interventions. It is also illustrated that even when using flexible hence relatively safe end-effectors, it is possible to reach acceptable tracking behaviour at relatively high frequencies.