Denis Nam1, Kenneth M Lin, Stephen M Howell, Maury L Hull. 1. Department of Orthopedic Surgery, Washington University School of Medicine/Barnes-Jewish Hospital, St. Louis, MO, USA, namd@wudosis.wustl.edu.
Abstract
PURPOSE: Kinematically aligned total knee arthroplasty (TKA) positions the femoral component at the natural angle and level of the distal (0°) and posterior (90°) joint line. This technique applies referencing guides at 0° and 90° that are adjusted to compensate for wear and kerf and perform resections equal in thickness to the femoral component. Knowing whether femoral bone and cartilage wear is predictable would assist in establishing general guidelines for adjusting the resection level of these two referencing guides. This study tests the hypothesis that femoral bone and cartilage wear is predictable at 0° and 90° in the varus and valgus osteoarthritic knee treated with TKA. METHODS: The study consists of 205 patients and 208 knees with Kellgren-Lawrence Grade 3 or 4 osteoarthritis and treated with a TKA. Each knee had a narrow slice (2 mm) preoperative 1.5 tesla magnetic resonance image in the sagittal plane. Femoral bone and cartilage wear at 0° and 90° was computed from best-fit circles superimposed on the peripheral boundary of the subchondral bone on the medial and lateral femoral condyles. RESULTS: Overall, 99.5% of knees had minimal bone wear (<1 mm) at 0° and 90°. In the 74% (154 of 208) of knees with a varus deformity, 92% at 0° and 2 % at 90° had >1 mm cartilage wear on the medial femoral condyle. In the 26% (54 of 208) of knees with a valgus deformity, 78% at 0° and 55% at 90° had ≥1 mm cartilage wear on the lateral femoral condyle. CONCLUSIONS: As a general guideline, adjustment for femoral bone wear is rarely required when performing kinematically aligned TKA. Most osteoarthritic knees require adjustment of the distal referencing guide to compensate for cartilage wear on the medial femoral condyle in the varus knee and the lateral femoral condyle in the valgus knee. Adjustment of the posterior referencing guide is required in about half of valgus osteoarthritic knees to compensate for lateral cartilage wear at 90°. Knowing that bone wear is rare and cartilage wear is predictable in varus and valgus Kellgren-Lawrence Grade 3 or 4 osteoarthritic knees helps establish general guidelines for adjusting the distal and posterior femoral referencing guides to restore the natural angle and level of the femoral joint lines when performing kinematically aligned TKA with generic instruments. LEVEL OF EVIDENCE: IV.
PURPOSE: Kinematically aligned total knee arthroplasty (TKA) positions the femoral component at the natural angle and level of the distal (0°) and posterior (90°) joint line. This technique applies referencing guides at 0° and 90° that are adjusted to compensate for wear and kerf and perform resections equal in thickness to the femoral component. Knowing whether femoral bone and cartilage wear is predictable would assist in establishing general guidelines for adjusting the resection level of these two referencing guides. This study tests the hypothesis that femoral bone and cartilage wear is predictable at 0° and 90° in the varus and valgus osteoarthritic knee treated with TKA. METHODS: The study consists of 205 patients and 208 knees with Kellgren-Lawrence Grade 3 or 4 osteoarthritis and treated with a TKA. Each knee had a narrow slice (2 mm) preoperative 1.5 tesla magnetic resonance image in the sagittal plane. Femoral bone and cartilage wear at 0° and 90° was computed from best-fit circles superimposed on the peripheral boundary of the subchondral bone on the medial and lateral femoral condyles. RESULTS: Overall, 99.5% of knees had minimal bone wear (<1 mm) at 0° and 90°. In the 74% (154 of 208) of knees with a varus deformity, 92% at 0° and 2 % at 90° had >1 mm cartilage wear on the medial femoral condyle. In the 26% (54 of 208) of knees with a valgus deformity, 78% at 0° and 55% at 90° had ≥1 mm cartilage wear on the lateral femoral condyle. CONCLUSIONS: As a general guideline, adjustment for femoral bone wear is rarely required when performing kinematically aligned TKA. Most osteoarthritic knees require adjustment of the distal referencing guide to compensate for cartilage wear on the medial femoral condyle in the varus knee and the lateral femoral condyle in the valgus knee. Adjustment of the posterior referencing guide is required in about half of valgus osteoarthritic knees to compensate for lateral cartilage wear at 90°. Knowing that bone wear is rare and cartilage wear is predictable in varus and valgus Kellgren-Lawrence Grade 3 or 4 osteoarthritic knees helps establish general guidelines for adjusting the distal and posterior femoral referencing guides to restore the natural angle and level of the femoral joint lines when performing kinematically aligned TKA with generic instruments. LEVEL OF EVIDENCE: IV.
Authors: Donald G Eckhoff; Joel M Bach; Victor M Spitzer; Karl D Reinig; Michelle M Bagur; Todd H Baldini; Nicolas M P Flannery Journal: J Bone Joint Surg Am Date: 2005 Impact factor: 5.284
Authors: H Gene Dossett; George J Swartz; Nicolette A Estrada; George W LeFevre; Bertram G Kwasman Journal: Orthopedics Date: 2012-02-17 Impact factor: 1.390
Authors: Felix Eckstein; C Kent Kwoh; Robert M Boudreau; Zhijie Wang; Michael J Hannon; Sebastian Cotofana; Martin I Hudelmaier; Wolfgang Wirth; Ali Guermazi; Michael C Nevitt; Markus R John; David J Hunter Journal: Ann Rheum Dis Date: 2012-06-23 Impact factor: 19.103
Authors: Richard B Frobell; Michael C Nevitt; Martin Hudelmaier; Wolfgang Wirth; Bradley T Wyman; Olivier Benichou; Donatus Dreher; Richard Davies; Jennifer H Lee; Frédéric Baribaud; Alberto Gimona; Felix Eckstein Journal: Arthritis Care Res (Hoboken) Date: 2010-05-23 Impact factor: 4.794
Authors: Jan M K Victor; David Bassens; Johan Bellemans; Sarper Gürsu; Aad A M Dhollander; Peter C M Verdonk Journal: Clin Orthop Relat Res Date: 2014-01 Impact factor: 4.176
Authors: Jeremy Riley; Joshua D Roth; Stephen M Howell; Maury L Hull Journal: Knee Surg Sports Traumatol Arthrosc Date: 2017-11-27 Impact factor: 4.342