Literature DB >> 23294792

Effect of dexamethasone-loaded poly(lactic-co-glycolic acid) microsphere/poly(vinyl alcohol) hydrogel composite coatings on the basic characteristics of implantable glucose sensors.

Yan Wang1, Santhisagar Vaddiraju, Liangliang Qiang, Xiaoming Xu, Fotios Papadimitrakopoulos, Diane J Burgess.   

Abstract

BACKGROUND: Hydrogels alone and in combination with microsphere drug delivery systems are being considered as biocompatible coatings for implantable glucose biosensors to prevent/minimize the foreign body response. Previously, our group has demonstrated that continuous release of dexamethasone from poly(lactic-co-glycolic acid) (PLGA) microsphere/poly(vinyl alcohol) (PVA) hydrogel composites can successfully prevent foreign body response at the implantation site. The objective of this study was to investigate the effect of this composite coating on sensor functionality.
METHODS: The PLGA microsphere/PVA hydrogel coatings were prepared and applied to glucose biosensors. The swelling properties of the composite coatings and their diffusivity to glucose were evaluated as a function of microsphere loading. Sensor linearity, response time, and sensitivity were also evaluated as a function of coating composition.
RESULTS: The PLGA microsphere/PVA hydrogel composite coating did not compromise sensor linearity (sensors were linear up to 30 mM), which is well beyond the physiological glucose range (2 to 22 mM). The sensor response time did increase in the presence of the coating (from 10 to 19 s); however, this response time was still less than the average reported values. Although the sensitivity of the sensors decreased from 73 to 62 nA/mM glucose when the PLGA microsphere loading in the PVA hydrogel changed from 0 to 100 mg/ml, this reduced sensitivity is acceptable for sensor functionality. The changes in sensor response time and sensitivity were due to changes in glucose permeability as a result of the coatings. The embedded PLGA microspheres reduced the fraction of bulk water present in the hydrogel matrix and consequently reduced glucose diffusion.
CONCLUSIONS: This study demonstrates that the PLGA microsphere/PVA hydrogel composite coatings allow sufficient glucose diffusion and sensor functionality and therefore may be utilized as a smart coating for implantable glucose biosensors to enhance their in vivo functionality.
© 2012 Diabetes Technology Society.

Entities:  

Mesh:

Substances:

Year:  2012        PMID: 23294792      PMCID: PMC3570887          DOI: 10.1177/193229681200600626

Source DB:  PubMed          Journal:  J Diabetes Sci Technol        ISSN: 1932-2968


  19 in total

Review 1.  Technologies for continuous glucose monitoring: current problems and future promises.

Authors:  Santhisagar Vaddiraju; Diane J Burgess; Ioannis Tomazos; Faquir C Jain; Fotios Papadimitrakopoulos
Journal:  J Diabetes Sci Technol       Date:  2010-11-01

Review 2.  Biosensors for real-time in vivo measurements.

Authors:  George S Wilson; Raeann Gifford
Journal:  Biosens Bioelectron       Date:  2005-01-15       Impact factor: 10.618

Review 3.  Factors determining hydrogel permeability.

Authors:  S H Gehrke; J P Fisher; M Palasis; M E Lund
Journal:  Ann N Y Acad Sci       Date:  1997-12-31       Impact factor: 5.691

4.  A review of the biocompatibility of implantable devices: current challenges to overcome foreign body response.

Authors:  Yoshinori Onuki; Upkar Bhardwaj; Fotios Papadimitrakopoulos; Diane J Burgess
Journal:  J Diabetes Sci Technol       Date:  2008-11

5.  Edge-plane microwire electrodes for highly sensitive H₂O₂ and glucose detection.

Authors:  Liangliang Qiang; Santhisagar Vaddiraju; Dipesh Patel; Fotios Papadimitrakopoulos
Journal:  Biosens Bioelectron       Date:  2011-02-18       Impact factor: 10.618

6.  Enhanced glucose sensor linearity using poly(vinyl alcohol) hydrogels.

Authors:  Santhisagar Vaddiraju; Hardeep Singh; Diane J Burgess; Faquir C Jain; Fotios Papadimitrakopoulos
Journal:  J Diabetes Sci Technol       Date:  2009-07-01

7.  Dexamethasone-loaded poly(lactic-co-glycolic) acid microspheres/poly(vinyl alcohol) hydrogel composite coatings for inflammation control.

Authors:  Siddhesh D Patil; Fotios Papadimitrakopoulos; Diane J Burgess
Journal:  Diabetes Technol Ther       Date:  2004-12       Impact factor: 6.118

8.  Concurrent delivery of dexamethasone and VEGF for localized inflammation control and angiogenesis.

Authors:  Siddhesh D Patil; Fotios Papadmitrakopoulos; Diane J Burgess
Journal:  J Control Release       Date:  2006-10-19       Impact factor: 9.776

9.  Controlling acute inflammation with fast releasing dexamethasone-PLGA microsphere/pva hydrogel composites for implantable devices.

Authors:  Upkar Bhardwaj; Radhakrishna Sura; Fotios Papadimitrakopoulos; Diane J Burgess
Journal:  J Diabetes Sci Technol       Date:  2007-01

10.  The effect of intensive treatment of diabetes on the development and progression of long-term complications in insulin-dependent diabetes mellitus.

Authors:  D M Nathan; S Genuth; J Lachin; P Cleary; O Crofford; M Davis; L Rand; C Siebert
Journal:  N Engl J Med       Date:  1993-09-30       Impact factor: 91.245

View more
  2 in total

1.  Crosslinked basement membrane-based coatings enhance glucose sensor function and continuous glucose monitoring in vivo.

Authors:  Ulrike Klueh; Izabela Ludzinska; Caroline Czajkowski; Yi Qiao; Donald L Kreutzer
Journal:  J Biomed Mater Res A       Date:  2017-09-19       Impact factor: 4.396

2.  Fluorescent Biocompatible Platinum-Porphyrin-Doped Polymeric Hybrid Particles for Oxygen and Glucose Biosensing.

Authors:  Gaurav Pandey; Rashmi Chaudhari; Bhavana Joshi; Sandeep Choudhary; Jaspreet Kaur; Abhijeet Joshi
Journal:  Sci Rep       Date:  2019-03-22       Impact factor: 4.379

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.