Literature DB >> 17211503

Effect of different types of enamel conditioners on the bond strength of orthodontic brackets.

A R Davari1, S Yassaei, A R Daneshkazemi, M H Yosefi.   

Abstract

AIM: A unique characteristic of some new bonding systems in operative dentistry is they combine conditioning and priming agents into a single acidic primer solution for simultaneous use on both enamel and dentin. Combining conditioning and priming into a single treatment step results in improvement in both time and cost-effectiveness to the clinician and, indirectly, to the patient. The purpose of this study was to determine the effects of the use of a self-etching primer on the bond strength of orthodontic brackets and on the bracket/adhesive failure mode. METHODS AND MATERIALS: Thirty-six fresh bovine incisors were collected and stored in a solution of 0.1% (weight/volume) thymol. The criteria for tooth selection included intact buccal enamel, no cracks caused by the presence of the extraction forceps, and no defects. The teeth were cleansed and polished with pumice and rubber prophylactic cups for ten seconds. Brackets were bonded to the teeth according to one of three protocols following the manufacturers' instructions--Group 1: Conventional multistep bonding system (control group) (n=12); Group 2: Self-etching primer system (n=12); and Group 3: Acid+self-etching primer system (n=12). Specimens were loaded to failure in a Zwick test machine (Zwick GmbH & Co, Ulm, Germany). Shear bond strengths were measured at a crosshead speed of 5 mm/min.
RESULTS: The mean shear bond strength in megapascals (Mpa) (standard deviation) were 11.7 (4.2), 10.5 (4.4), and 10.9 (4.8) for Groups 1, 2, and 3, respectively. The analysis of variance (ANOVA) was used to compare the three groups. The results indicated no significant difference in the bond strength between the three groups (P=0.800). The results of the Chi square test, evaluating the residual adhesives on the enamel surfaces, revealed no significant difference between the three groups (P=0.554).
CONCLUSION: Results of the present in vitro study indicate the use of self-etching primers may be an alternative to conventional phosphoric acid pre-treatment in orthodontic bonding.

Entities:  

Mesh:

Substances:

Year:  2007        PMID: 17211503

Source DB:  PubMed          Journal:  J Contemp Dent Pract        ISSN: 1526-3711


  4 in total

1.  Effect of prophylactic pastes containing active ingredients on the enamel-bracket bond strength of etch-and-rinse and self-etching systems.

Authors:  Sarah Al-Twaijri; Grace Viana; Ana K Bedran-Russo
Journal:  Angle Orthod       Date:  2011-05-13       Impact factor: 2.079

2.  Shear bond strength of a bracket-bonding system cured with a light-emitting diode or halogen-based light-curing unit at various polymerization times.

Authors:  Sanjay Prasad Gupta; Basanta Kumar Shrestha
Journal:  Clin Cosmet Investig Dent       Date:  2018-04-10

3.  Shear Bond Strength of Orthodontic Brackets Fixed with Remineralizing Adhesive Systems after Simulating One Year of Orthodontic Treatment.

Authors:  Gisele Lima Bezerra; Carlos Rocha Gomes Torres; Mateus Rodrigues Tonetto; Alvaro Henrique Borges; Milton Carlos Kuga; Matheus Coelho Bandeca; Leily Macedo Firoozmand
Journal:  ScientificWorldJournal       Date:  2015-08-26

4.  Shear bond strength and debonding characteristics of a new premixed self-etching with a reference total-etch adhesive.

Authors:  Michael Schauseil; Sonja Blöcher; Andreas Hellak; Matthias J Roggendorf; Steffen Stein; Heike Korbmacher-Steiner
Journal:  Head Face Med       Date:  2016-04-30       Impact factor: 2.151

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.