Stress relaxation of porcine gluteus muscle subjected to sudden transverse deformation as related to pressure sore modeling.

Computational studies of deep pressure sores (DPS) in skeletal muscles require information on viscoelastic constitutive behavior of muscles, particularly when muscles are loaded transversally as during bone-muscle interaction in sitting and lying immobilized patients. In this study, we measured transient shear moduli G(t) of fresh porcine muscles in vitro using the indentation method. We employed a custom-made pneumatic device that allowed rapid (2000 mms) 4 mm indentations. We tested 8 gluteus muscles, harvested from 5 adult pigs. Each muscle was indented transversally (perpendicularly to the direction of fibers) at 3 different sites, 7 times per site, to obtain nonpreconditioned (NPC) and preconditioned (PC) G(t) data. Short-term (GS) and long-term (GL) shear moduli were obtained directly from experiments. We further fitted measured G(t) data to a biexponential equation G(t) = G1 x exp(-t/tau1)+ G2 x exp(-t/tau2) + Ginfinity, which provided good fit, visually and in terms of the correlation coefficients. Typically, plateau of the stress relaxation curves (defined as 10% difference from final GL) was evident approximately 20 s after indentation. Short-term shear moduli GS (mean NPC: 8509 Pa, PC: 5711 Pa) were greater than long-term moduli GL (NPC: 609 Pa, PC: 807 Pa) by about an order of magnitude. Statistical analysis of parameters showed that only G2 was affected by preconditioning, while GL, GS, Ginfinity, tau1, tau2, and G1 properties were unaffected. Since DPS develop over time scales of minutes to hours, but most stress relaxation occurs within approximately 20 s, the most relevant property for computational modeling is GL (mean approximately 700 Pa), which is, conveniently, unaffected by preconditioning.