Literature DB >> 16485404

Technique for routine output verification of Leipzig applicators with a well chamber.

J Pérez-Calatayud1, D Granero, F Ballester, V Crispín, R Van der Laarse.   

Abstract

The H-type Leipzig applicators are accessories of the microSelectron-HDR system (Nucletron, Veenendaal, The Netherlands) for treatment of superficial malignancies. Recently, the dose rate distributions in liquid water for the whole set of applicators using both source models available for the microSelectron-HDR afterloaders have been obtained by means of the experimentally validated Monte Carlo (MC) code GEANT4. Also an output table (cGy/hU) at 3 mm depth on the applicator central axis was provided. The output verification of these applicators by the user, prior to their clinical use, present practical problems: small detectors such as thermoluminescent dosimeters or parallel-plate ionization chambers are not easily used for verification in a clinical environment as they require a rigid setup with the Leipzig applicator and a phantom. In contrast, well-type ionization chambers are readily available in radiotherapy departments. This study presents a technique based on the HDR1000Plus well chamber (Standar Imaging) measurements with a special insert, which allows the output verification of the H-type Leipzig applicators on a routine basis. This technique defines correspondence factors (CF) between the in water dose rate output of the Leipzig applicators (cGy/hU) obtained with MC and the reading on the well chamber with the special insert, normalized to the HDR calibration factor with the HDR insert and to the source strength. To commission the applicators (with the well chamber and the special insert used), the physicist should check if the CF value agrees with its tabulated values presented in this work. If the differences are within 5% the tabulated output values can be used in clinical dosimetry. This technique allows the output validation of the Leipzig applicators with a well chamber widely used for HDR Ir-192 source strength measurements. It can easily be adapted to other types of well chambers for HDR source output verification.

Entities:  

Mesh:

Year:  2006        PMID: 16485404     DOI: 10.1118/1.2138008

Source DB:  PubMed          Journal:  Med Phys        ISSN: 0094-2405            Impact factor:   4.071


  5 in total

1.  Surface dose characterisation of the Varian Ir-192 HDR conical surface applicator set with a vertically orientated source.

Authors:  Konrad Buchauer; Guido Henke; Hans Schiefer; Ludwig Plasswilm
Journal:  Strahlenther Onkol       Date:  2014-08-01       Impact factor: 3.621

2.  Dosimetric characterization and output verification for conical brachytherapy surface applicators. Part II. High dose rate 192Ir sources.

Authors:  Regina K Fulkerson; John A Micka; Larry A DeWerd
Journal:  Med Phys       Date:  2014-02       Impact factor: 4.071

3.  The initial experience of electronic brachytherapy for the treatment of non-melanoma skin cancer.

Authors:  Ajay Bhatnagar; Alphonse Loper
Journal:  Radiat Oncol       Date:  2010-09-28       Impact factor: 3.481

4.  Dosimetric characteristics of a new unit for electronic skin brachytherapy.

Authors:  Teresa Garcia-Martinez; Jan-Pieter Chan; Jose Perez-Calatayud; Facundo Ballester
Journal:  J Contemp Brachytherapy       Date:  2014-02-19

Review 5.  Commissioning and quality assurance procedures for the HDR Valencia skin applicators.

Authors:  Domingo Granero; Cristian Candela-Juan; Facundo Ballester; Zoubir Ouhib; Javier Vijande; Jose Richart; Jose Perez-Calatayud
Journal:  J Contemp Brachytherapy       Date:  2016-11-04
  5 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.