Power output of the lower limb during variable inertial loading: a comparison between methods using single and repeated contractions.

The power-inertial load relationship of the lower limb muscles was studied during a single leg thrust using the Modified Nottingham Power Rig (mNPR) and during cycling exercise in nine young male subjects. The relationship between peak power and inertial load showed a parabolic-like relationship for mNPR exertions, with a peak [937 (SD 246) W] at 0.158 kg m(2), this being significantly (P <0.05) different from the power generated at both the lowest [723 (162) W] and highest [756 (206) W] inertial loads. In contrast, for cycling exercise power output did not differ significantly between inertial loads, except at the lowest inertia where power output was significantly ( P<0.05) less compared with all other inertial loads. Maximum peak power output during cycling was 1,620 (336) W, which was significantly (P <0.05) greater than that recorded on the mNPR. However, a close association was observed between the mean power generated by each method (r=0.84, P<0.05). The results suggest that during a single contraction a range of inertial loads is required to allow peak power to be expressed. Above a certain critical value, this is unnecessary during cycling movements where the load can be repeatedly accelerated.