Literature DB >> 11425148

Ultrasound phased arrays for prostate treatment.

J S Tan1, L A Frizzell, N Sanghvi, S J Wu, R Seip, J T Kouzmanoff.   

Abstract

The effect of array geometry on the steering performance of ultrasound phased arrays is examined theoretically, in order to maximize array performance under the given anatomical constraints. This paper evaluates the performance of arrays with spherical and cylindrical geometry, determined by using computer simulations of the pressure fields produced at various extremes of steering. The spherical segment arrays were truncated for insertion into the rectum, and contained either annular or linear elements. The cylindrical arrays were either flat or had a variable curvature applied along their length. Fields were computed by dividing the array elements into many point sources. The effectiveness of an array configuration when steered to a particular focal location was assessed by defining a parameter, G, as the ratio of the intensity at the desired focus to the maximum intensity of any unwanted lobes. The performance of truncated spherical arrays with annular elements was evaluated for focal steering along the array axis (in depth, in the z direction). When steered 15 mm toward the source, these truncated spherical annular arrays exhibited excellent performance, with G>5.7 for arrays containing more than 10 elements. Similarly, the spherical arrays with linear elements performed well when steered along the array axis to the same degree, with G>7 (for element widths up to 3 lambda), though many more array elements were required. However, when these arrays were steered 15 mm laterally, along the length of the prostate (the y direction), the value for G fell below 1 for element widths greater than about 1.6 lambda. It was found that the cylindrical arrays performed much better for y-direction steering (G>4, for 60 mm arrays with an element width of 1.75 lambda), but their performance was poorer when steered in the z direction (G approximately 4 for an element width of 1.5 lambda). In order to find a compromise between these extremes, a curved cylindrical array was examined, which was a cylindrical array with additional curvature along its length. These curved cylindrical arrays yielded performance between that of spherical linear arrays and cylindrical arrays, with better steering along the y direction than the spherical arrays and better z-direction steering than the cylindrical arrays.

Mesh:

Year:  2001        PMID: 11425148     DOI: 10.1121/1.1373444

Source DB:  PubMed          Journal:  J Acoust Soc Am        ISSN: 0001-4966            Impact factor:   1.840


  5 in total

1.  Optimal simulations of ultrasonic fields produced by large thermal therapy arrays using the angular spectrum approach.

Authors:  Xiaozheng Zeng; Robert J McGough
Journal:  J Acoust Soc Am       Date:  2009-05       Impact factor: 1.840

2.  Feasibility of MR-temperature mapping of ultrasonic heating from a CMUT.

Authors:  Serena H Wong; Ronald D Watkins; Mario Kupnik; Kim Butts Pauly; Butrus T Khuri-Yakub
Journal:  IEEE Trans Ultrason Ferroelectr Freq Control       Date:  2008-04       Impact factor: 2.725

3.  Amplitude modulated chirp excitation to reduce grating lobes and maintain ultrasound intensity at the focus of an array.

Authors:  Chandra P Karunakaran; Michael L Oelze
Journal:  Ultrasonics       Date:  2013-04-16       Impact factor: 2.890

4.  Design aspects of focal beams from high-intensity arrays.

Authors:  Douglas Stephens; Dustin Kruse; Shengping Qin; Katherine Ferrara
Journal:  IEEE Trans Ultrason Ferroelectr Freq Control       Date:  2011-08       Impact factor: 2.725

5.  MR thermometry characterization of a hyperthermia ultrasound array designed using the k-space computational method.

Authors:  Osama M Al-Bataineh; Christopher M Collins; Eun-Joo Park; Hotaik Lee; Nadine Barrie Smith
Journal:  Biomed Eng Online       Date:  2006-10-25       Impact factor: 2.819

  5 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.