BACKGROUND AND OBJECTIVE: The purpose of this study was to evaluate sealant shear bond strength on bovine enamel with standard acid etching compared with CO(2) laser etching. STUDY DESIGN/ MATERIALS AND METHODS: Bovine enamel was prepared either by acid or laser etching and divided into four experimental groups, either acid or laser-etched teeth with or without a primer. A gelatin capsule was used to place the sealant on the prepared enamel surface and the bond tested in shear. Also surface roughness was evaluated by using a surface analyzer and an atomic force microscope. RESULTS: Shear bond strength results were the following: acid etch = 8.8 +/- 3.8 MPa, acid etch with primer = 10.3 +/- 5.5 MPa, laser etch = 4.0 +/- 1.1 MPa, and laser etch with primer = 6.2 +/- 2.3 MPa. Analysis of variance statistical analysis found no significant difference in bond strength between the acid-etched groups. However, the laser-etched groups had significantly lower bond strengths from the acid-etched teeth. In addition, a significant difference was observed between the laser-etched groups, where the use of the primer helped to increase the bond strength of the sealants. The surface roughness was significantly greater on the laser-etched teeth at the microm level (by using a surface analyzer) from the acid-etched and the control specimens. No difference in roughness (by using an atomic force microscope) was observed at the nanometer level between the laser and acid-etched teeth. CONCLUSION: For these particular settings, the laser-etched teeth resulted in lower bond strengths to enamel and the use of a primer increased the bond strength for laser-etched teeth only. Copyright 2000 Wiley-Liss, Inc.
BACKGROUND AND OBJECTIVE: The purpose of this study was to evaluate sealant shear bond strength on bovine enamel with standard acid etching compared with CO(2) laser etching. STUDY DESIGN/ MATERIALS AND METHODS:Bovine enamel was prepared either by acid or laser etching and divided into four experimental groups, either acid or laser-etched teeth with or without a primer. A gelatin capsule was used to place the sealant on the prepared enamel surface and the bond tested in shear. Also surface roughness was evaluated by using a surface analyzer and an atomic force microscope. RESULTS: Shear bond strength results were the following: acid etch = 8.8 +/- 3.8 MPa, acid etch with primer = 10.3 +/- 5.5 MPa, laser etch = 4.0 +/- 1.1 MPa, and laser etch with primer = 6.2 +/- 2.3 MPa. Analysis of variance statistical analysis found no significant difference in bond strength between the acid-etched groups. However, the laser-etched groups had significantly lower bond strengths from the acid-etched teeth. In addition, a significant difference was observed between the laser-etched groups, where the use of the primer helped to increase the bond strength of the sealants. The surface roughness was significantly greater on the laser-etched teeth at the microm level (by using a surface analyzer) from the acid-etched and the control specimens. No difference in roughness (by using an atomic force microscope) was observed at the nanometer level between the laser and acid-etched teeth. CONCLUSION: For these particular settings, the laser-etched teeth resulted in lower bond strengths to enamel and the use of a primer increased the bond strength for laser-etched teeth only. Copyright 2000 Wiley-Liss, Inc.
Authors: Daniel Nguyen; Kwang Chang; Saba Hedayatollahnajafi; Michal Staninec; Kenneth Chan; Robert Lee; Daniel Fried Journal: J Biomed Opt Date: 2011-07 Impact factor: 3.170