Quantitative angiography during coronary angioplasty with a single angiographic view: a comparison of automated edge detection and videodensitometric techniques.

Little information is available on the reliability of coronary luminal measurements obtained from quantitative analysis of a single angiographic view, an approach that is central to the practical use of on-line quantitative angiography. In the present study we investigated the contribution of two different techniques of quantitative angiography, edge detection (ED) and videodensitometry (VD), to the application of this concept during coronary angioplasty. Forty-six balloon angioplasty procedures were included in this study, all of them performed in a stenosis located in the mid right coronary segment. This coronary location was chosen to optimize data collection on luminal morphology and to minimize the number of factors that may adversely affect quantitative analysis with both techniques. In all cases two orthogonal angiographic projections were obtained before, after balloon dilatation, and at follow-up. Correlation coefficients and differences between orthogonal measurements obtained with each technique were used to evaluate the agreement between orthogonal readings at every stage of the procedure. The obtained correlation coefficients and mean differences (MD) between orthogonal measurements were as follows: before percutaneous transluminal coronary angiography (PTCA), 0.67 (MD 0.01 +/- 0.47 mm2) and 0.57 (MD 0.05 +/- 0.64 mm2) for ED and VD, respectively (Pitman's test for SD, p < 0.05); after balloon dilatation, 0.32 (MD -0.56 +/- 1.53 mm2) and 0.53 (MD -0.15 +/- 1.43 mm2) for ED and VD, respectively (paired t test for MD, p < 0.05); and at follow-up 0.79 (MD -0.15 +/- 0.97 mm2) and 0.73 (MD 0.17 +/- 1.16 mm2) for ED and VD, respectively (p = NS).(ABSTRACT TRUNCATED AT 250 WORDS)