Sadashige Uemura1, Atsushi Yoshida2, Hisako Kuyama2. 1. Division of Chest Wall Surgery, Nishinomiya Watanabe Cardiovascular Center, 3-25, Ikeda-cho, Nishinomiya, 662-0911, Japan. sadauemura@gmail.com. 2. Department of Pediatric Surgery, Kawasaki Medical School, 577 Matsushima, Kurashiki, Okayama, 701-0192, Japan.
Abstract
PURPOSE: For the evaluation of the chest wall deformity, we adopted a non-invasive 3D body scanning system. The objective of this study is to evaluate surgical effect on the whole thorax using 3D scanning technique before and after Nuss procedure. METHODS: We performed 3D body scanning using Structure Sensor (Occipital Inc, USA) in 11 symmetric patients (average age 13 ± 3.2) under general anesthesia before and after Nuss procedure. Using the scanned data, the improved chest wall was analyzed using 3D-Rugle (Medic Engineering, Japan) imaging software. Preoperative and postoperative 3D data were super-imposed and a thoracic elevating distance in the line of the axial and sagittal section through the deepest point was calculated. Pre- and postoperative external sternal angle (ESA) were calculated from the scanned data. RESULTS: Mean thoracic elevation distance at the deepest point was 38.6 ± 6.1 mm and it was 28.4 ± 5.1 mm and 19.4 ± 4.9 mm at 4 cm and 8 cm cranial side, respectively. Average ESA improved from 3.9 ± 1.6 degrees to 15.0 ± 1.1 degrees after the operation. CONCLUSION: Chest depression was effectively elevated 39 mm at the deepest point after Nuss procedure. An indirect elevation effect by pectus bars was found on the wide area of the anterior chest.
PURPOSE: For the evaluation of the chest wall deformity, we adopted a non-invasive 3D body scanning system. The objective of this study is to evaluate surgical effect on the whole thorax using 3D scanning technique before and after Nuss procedure. METHODS: We performed 3D body scanning using Structure Sensor (Occipital Inc, USA) in 11 symmetric patients (average age 13 ± 3.2) under general anesthesia before and after Nuss procedure. Using the scanned data, the improved chest wall was analyzed using 3D-Rugle (Medic Engineering, Japan) imaging software. Preoperative and postoperative 3D data were super-imposed and a thoracic elevating distance in the line of the axial and sagittal section through the deepest point was calculated. Pre- and postoperative external sternal angle (ESA) were calculated from the scanned data. RESULTS: Mean thoracic elevation distance at the deepest point was 38.6 ± 6.1 mm and it was 28.4 ± 5.1 mm and 19.4 ± 4.9 mm at 4 cm and 8 cm cranial side, respectively. Average ESA improved from 3.9 ± 1.6 degrees to 15.0 ± 1.1 degrees after the operation. CONCLUSION: Chest depression was effectively elevated 39 mm at the deepest point after Nuss procedure. An indirect elevation effect by pectus bars was found on the wide area of the anterior chest.
Entities:
Keywords:
3D body scanning; Chest wall; Nuss procedure; Pectus excavatum; Postoperative improvement
Authors: Shawn D St Peter; David Juang; Carissa L Garey; Carey A Laituri; Daniel J Ostlie; Ronald J Sharp; Charles L Snyder Journal: J Pediatr Surg Date: 2011-12 Impact factor: 2.545