INTRODUCTION: Fibrinogen concentrates are widely used to restore clot stability in situations of bleeding. Fibrinogen preparations are produced using different production methods, resulting in different compounds. Thus, different preparations might have a distinct impact on blood coagulation. We tested the effect of fibrinogen concentrates Haemocomplettan® (CSL Behring, Marburg, Germany) and fibryga® (Octapharma GmbH, Langenfeld, Germany) on the impairments induced by 60% dilutional coagulopathy in vitro. MATERIALS AND METHODS: The influence of the fibrinogen concentrates fibryga® and Haemocomplettan® on colloid (gelatine, hydroxyethyl starch [HES], albumin)-induced or crystalloid (Ringer's acetate)-induced dilutional coagulopathy was analysed using rotational thromboelastometry (ROTEM®) and standard laboratory tests. The following experimental conditions were analysed in vitro: whole blood, 60% dilution (40% blood and 60% diluent) ± 50 or 100 mg/kg<sup>-1</sup> fibryga® or Haemocomplettan®, respectively. RESULTS: Dilution with either diluent resulted in prolonged clotting time (CT) in an extrinsic activated test (CT<sub>EXTEM</sub>) and decreased maximum clot firmness (MCF<sub>FIBTEM</sub>) as expressed, e.g., by gelatine: (59.5 s [62/54.8] vs. 95 s [102.8/86.8]; p < 0.001 and 14 mm [16/10.5] vs. 3 mm [4-3]; p < 0.001). Substitution after 60% dilution with HES resulted in no difference between the preparations, except for shorter thrombin time with fibryga® (14 s [15/14] vs. 18 s [18.8/17]; p = 0.0093; low dose). CT<sub>EXTEM</sub> was higher with Haemocomplettan® in a gelatine-induced dilution (51 s [54.5/47.5] vs. 63 s [71/60.3]; p = 0.0202; low dose) whereas thrombin time was lower with fibryga® (19.5 s [20.8/19] vs. 27 s [29/25.3]; p = 0.0017). In dilution with albumin, differences in CT<sub>EXTEM</sub> (69 s [76.5/66] vs. 56 s [57/53.3]; p = 0.0114; low dose) and thrombin time (18 s [18/17] vs. 24.5 s [25.8/24]; p = 0.0202; low dose) were seen. In dilution with crystalloid solution, again differences in CT<sub>EXTEM</sub> (53.5 s [57.8/53] vs. 45 s [47/43]; p = 0.035; low dose) and thrombin time (17 s [17/16] vs. 23.5 s [24/23]; p = 0.0014; low dose) were seen. Fibrinogen levels were more increased by high-dose substitution of both preparations. CONCLUSION: Based on this data it can be stated that both fibryga® and Haemocomplettan® had the same performance in our in vitro model except for CT<sub>EXTEM</sub> and thrombin time.
INTRODUCTION: Fibrinogen concentrates are widely used to restore clot stability in situations of bleeding. Fibrinogen preparations are produced using different production methods, resulting in different compounds. Thus, different preparations might have a distinct impact on blood coagulation. We tested the effect of fibrinogen concentrates Haemocomplettan® (CSL Behring, Marburg, Germany) and fibryga® (Octapharma GmbH, Langenfeld, Germany) on the impairments induced by 60% dilutional coagulopathy in vitro. MATERIALS AND METHODS: The influence of the fibrinogen concentrates fibryga® and Haemocomplettan® on colloid (gelatine, hydroxyethyl starch [HES], albumin)-induced or crystalloid (Ringer's acetate)-induced dilutional coagulopathy was analysed using rotational thromboelastometry (ROTEM®) and standard laboratory tests. The following experimental conditions were analysed in vitro: whole blood, 60% dilution (40% blood and 60% diluent) ± 50 or 100 mg/kg<sup>-1</sup> fibryga® or Haemocomplettan®, respectively. RESULTS: Dilution with either diluent resulted in prolonged clotting time (CT) in an extrinsic activated test (CT<sub>EXTEM</sub>) and decreased maximum clot firmness (MCF<sub>FIBTEM</sub>) as expressed, e.g., by gelatine: (59.5 s [62/54.8] vs. 95 s [102.8/86.8]; p < 0.001 and 14 mm [16/10.5] vs. 3 mm [4-3]; p < 0.001). Substitution after 60% dilution with HES resulted in no difference between the preparations, except for shorter thrombin time with fibryga® (14 s [15/14] vs. 18 s [18.8/17]; p = 0.0093; low dose). CT<sub>EXTEM</sub> was higher with Haemocomplettan® in a gelatine-induced dilution (51 s [54.5/47.5] vs. 63 s [71/60.3]; p = 0.0202; low dose) whereas thrombin time was lower with fibryga® (19.5 s [20.8/19] vs. 27 s [29/25.3]; p = 0.0017). In dilution with albumin, differences in CT<sub>EXTEM</sub> (69 s [76.5/66] vs. 56 s [57/53.3]; p = 0.0114; low dose) and thrombin time (18 s [18/17] vs. 24.5 s [25.8/24]; p = 0.0202; low dose) were seen. In dilution with crystalloid solution, again differences in CT<sub>EXTEM</sub> (53.5 s [57.8/53] vs. 45 s [47/43]; p = 0.035; low dose) and thrombin time (17 s [17/16] vs. 23.5 s [24/23]; p = 0.0014; low dose) were seen. Fibrinogen levels were more increased by high-dose substitution of both preparations. CONCLUSION: Based on this data it can be stated that both fibryga® and Haemocomplettan® had the same performance in our in vitro model except for CT<sub>EXTEM</sub> and thrombin time.
Authors: C Gaarder; P A Naess; E Frischknecht Christensen; P Hakala; L Handolin; H E Heier; K Ivancev; P Johansson; A Leppäniemi; F Lippert; H M Lossius; H Opdahl; J Pillgram-Larsen; O Røise; N O Skaga; E Søreide; J Stensballe; E Tønnessen; A Töttermann; P Ortenwall; A Ostlund Journal: Scand J Surg Date: 2008 Impact factor: 2.360
Authors: Christoph Johannes Schlimp; Janne Cadamuro; Cristina Solomon; Heinz Redl; Herbert Schöchl Journal: Blood Transfus Date: 2012-12-13 Impact factor: 3.443