Literature DB >> 32028774

T1rho and T2 mapping of ankle cartilage of female and male ballet dancers.

Saya Horiuchi1, Hon J Yu1, Alex Luk1, Adam Rudd1, Jimmy Ton1, Edward Kuoy1, Jeffrey A Russell2, Kelli Sharp3, Hiroshi Yoshioka1.   

Abstract

BACKGROUND: Since ballet dancers begin their training before skeletal maturity, accurate and non-invasive identification of cartilage diseases is clinically important. Angle-dependent analysis of T1rho and T2 sequences can be useful for quantification of the composition of cartilage.
PURPOSE: To investigate the angle-dependent T1rho and T2 profiles of ankle cartilage in non-dancers and dancers.
MATERIAL AND METHODS: Ten female non-dancers, ten female dancers, and 9 male dancers were evaluated using T1rho and T2 mapping sequences. Manual segmentation of talar and tibial cartilage on these images was performed by two radiologists. Inter- and intra-rater reliabilities were calculated using intraclass correlation coefficients (ICCs) and Bland-Altman analysis. Mean thickness and volume of cartilage were estimated. Angle-dependent relaxation time profiles of talar and tibial cartilage were created.
RESULTS: ICCs of the number of segmented pixels were poor to excellent. Bland-Altman plots indicated that differences were associated with segment sizes. Segmented cartilage on T1rho demonstrated larger thickness and volume than those on T2 in all populations. Male dancers showed larger cartilage thickness and volume than female dancers and non-dancers. Each cartilage demonstrated angular-dependent T1rho and T2 profiles. Minimal T1rho and T2 values were observed at approximately 180°-200°; higher values were seen at the angle closer to the magic angle. Minimal T2 value of talar cartilage of dancers was larger than that of non-dancers.
CONCLUSION: In this small cohort study, regional and sex variations of ankle cartilage T1rho and T2 values in dancers and non-dancers were demonstrated using an angle-dependent approach.

Keywords:  Ankle; T1rho mapping; T2 mapping; ballet dancer; cartilage; quantitative magnetic resonance imaging

Mesh:

Year:  2020        PMID: 32028774     DOI: 10.1177/0284185120902381

Source DB:  PubMed          Journal:  Acta Radiol        ISSN: 0284-1851            Impact factor:   1.990


  1 in total

1.  Accuracy of MRI-Based Talar Cartilage Thickness Measurement and Talus Bone and Cartilage Modeling: Comparison with Ground-Truth Laser Scan Measurements.

Authors:  Carly A Lockard; Ingrid K Stake; Alex W Brady; Madeleine G DeClercq; Kira K Tanghe; Brenton W Douglass; Erik Nott; Charles P Ho; Thomas O Clanton
Journal:  Cartilage       Date:  2020-12-03       Impact factor: 3.117

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.