PURPOSE: Varus deformity of knee osteoarthritis was formed by both intra-articular and extra-articular pathologies. Such intra-articular deformities could not be fully corrected by a medial open-wedge high tibial osteotomy (HTO), which was performed as an extra-articular procedure. Therefore, the purpose of this study was to investigate whether any residual varus was left inside the joint after HTO in the patients with knee osteoarthritis, and a correlation of the residual varus could be traced. METHODS: This study involved 66 patients (66 knees) undergoing HTO for medial knee osteoarthritis. The percentage of mechanical axis (%MA), mechanical femorotibial angle (mFTA), mechanical lateral distal femoral angle (mLDFA), mechanical medial proximal tibial angle (mMPTA) and joint line convergence angle (JLCA) were measured on radiographs of the full-length legs preoperatively and 6 months postoperatively. The relationship between changes in the JLCA and alignment correction was assessed. The postoperative residual JLCA was categorized as the optimal (postoperative JLCA ≤ 2°), the acceptable (2° < postoperative JLCA ≤ 5°), and the unacceptable (postoperative JLCA > 5°) to analyze its correlation with pre- or intra-operative factors. RESULTS: Average %MA and mFTA were improved from 5.5 to 60% and from 190.2° to 176.4°, respectively. There was no change in mLDFA, whereas mMPTA changed from 80.3° to 91.8°. JLCA changed from 4.2° to 2.7°. The analyses of multiple linear regression showed that the preoperative JLCA and postoperative changes in mechanical alignment (%MA, mFTA and mMPTA) were two important variables dependently associated with differences in JLCAs postoperatively. However, postoperative JLCAs showed a stronger correlation to preoperative JLCAs than to changes in mechanical alignment postoperatively. A Chi-square analysis showed a significantly higher percentage of patients achieved acceptable postoperative JLCAs in the preoperative JLCA ≤ 6° group (78.8%) compared to the preoperative JLCA > 6° group (6.1%). Therefore, 6° of JLCA was suggested to be a tipping point. CONCLUSIONS: The capability of HTO to correct intra-articular varus deformities, which was represented by JLCAs, is limited. Postoperative residual JLCAs were correlated primarily to preoperative JLCA values and total alignment correction, while the former accounted for most. A preoperative JLCA of 6° was suggested to be a tipping point, and a larger value indicated more than 5° residual JLCA after the HTO.
PURPOSE:Varus deformity of knee osteoarthritis was formed by both intra-articular and extra-articular pathologies. Such intra-articular deformities could not be fully corrected by a medial open-wedge high tibial osteotomy (HTO), which was performed as an extra-articular procedure. Therefore, the purpose of this study was to investigate whether any residual varus was left inside the joint after HTO in the patients with knee osteoarthritis, and a correlation of the residual varus could be traced. METHODS: This study involved 66 patients (66 knees) undergoing HTO for medial knee osteoarthritis. The percentage of mechanical axis (%MA), mechanical femorotibial angle (mFTA), mechanical lateral distal femoral angle (mLDFA), mechanical medial proximal tibial angle (mMPTA) and joint line convergence angle (JLCA) were measured on radiographs of the full-length legs preoperatively and 6 months postoperatively. The relationship between changes in the JLCA and alignment correction was assessed. The postoperative residual JLCA was categorized as the optimal (postoperative JLCA ≤ 2°), the acceptable (2° < postoperative JLCA ≤ 5°), and the unacceptable (postoperative JLCA > 5°) to analyze its correlation with pre- or intra-operative factors. RESULTS: Average %MA and mFTA were improved from 5.5 to 60% and from 190.2° to 176.4°, respectively. There was no change in mLDFA, whereas mMPTA changed from 80.3° to 91.8°. JLCA changed from 4.2° to 2.7°. The analyses of multiple linear regression showed that the preoperative JLCA and postoperative changes in mechanical alignment (%MA, mFTA and mMPTA) were two important variables dependently associated with differences in JLCAs postoperatively. However, postoperative JLCAs showed a stronger correlation to preoperative JLCAs than to changes in mechanical alignment postoperatively. A Chi-square analysis showed a significantly higher percentage of patients achieved acceptable postoperative JLCAs in the preoperative JLCA ≤ 6° group (78.8%) compared to the preoperative JLCA > 6° group (6.1%). Therefore, 6° of JLCA was suggested to be a tipping point. CONCLUSIONS: The capability of HTO to correct intra-articular varus deformities, which was represented by JLCAs, is limited. Postoperative residual JLCAs were correlated primarily to preoperative JLCA values and total alignment correction, while the former accounted for most. A preoperative JLCA of 6° was suggested to be a tipping point, and a larger value indicated more than 5° residual JLCA after the HTO.
Entities:
Keywords:
Extra-articular varus deformity; High tibial osteotomy; Intra-articular varus deformity; Joint line convergence angle; Knee osteoarthritis; Varus deformity
Authors: P Behrendt; R Akoto; I Bartels; G Thürig; H Fahlbusch; A Korthaus; D Dalos; M Hoffmann; K-H Frosch; M Krause Journal: Knee Surg Sports Traumatol Arthrosc Date: 2022-08-22 Impact factor: 4.114
Authors: A Cazor; A Schmidt; J Shatrov; T Alqahtani; P Neyret; Elliot Sappey-Marinier; C Batailler; S Lustig; E Servien Journal: Knee Surg Sports Traumatol Arthrosc Date: 2022-08-29 Impact factor: 4.114