Literature DB >> 30055877

Comparison of a highly porous titanium cup (Tritanium) and a conventional hydroxyapatite-coated porous titanium cup: A retrospective analysis of clinical and radiological outcomes in hip arthroplasty among Japanese patients.

Shinji Yoshioka1, Shunji Nakano2, Yutaka Kinoshita2, Masaru Nakamura2, Tomohiro Goto3, Daisuke Hamada3, Koichi Sairyo3.   

Abstract

BACKGROUND: The use of 3-dimensional highly porous acetabular cups is increasing. Their structure and mechanical properties mimic those of natural bone; therefore, they should promote stronger biological fixation. In our experience with total hip arthroplasty, radiolucent lines are observed when a 3-dimensional highly porous cup (Stryker Tritanium) is used. We compared the clinical and radiographic results between a Tritanium cup and a conventional cup (Stryker Trident HA) over a short time period.
METHOD: We retrospectively compared consecutive cases of primary total hip arthroplasty using a Tritanium cup (130 cases in 118 patients) and a matched cohort using a Trident cap (130 cases in 130 patients) between January 2011 and December 2014.
RESULTS: The mean follow-up duration was 41.3 and 38.1 months (p = 0.06) for the Tritanium and Trident groups, respectively. There were significant differences between the groups for radiolucent lines, cup abduction angle, and cup-center-edge angle. There were no significant differences in the clinical results. Radiolucent lines increased in the Tritanium group (36.1% at 3 months and 60.7% at final follow-up), whereas they decreased in the Trident group (2.5% at 3 months and 0.8% at final follow-up). The occurrence of radiolucent lines was significantly higher in the Tritanium group than in the Trident group at each follow-up period. Radiolucent lines were seen in 36.1% of patients in the Tritanium group during follow-up, without initial gaps. One cup loosening in the Tritanium group was identified at the final follow-up evaluation.
CONCLUSION: Both groups showed successful clinical results over short-term follow-up; however, the Tritanium group had a significantly higher rate of radiolucent line occurrence around the cups than did the Trident group. Thus, radiolucent lines can occur when using highly porous titanium cups; these lines indicate the possibility of future cup loosening. Longer follow-up and assessment of the results of using this implant are necessary.
Copyright © 2018 The Japanese Orthopaedic Association. Published by Elsevier B.V. All rights reserved.

Entities:  

Mesh:

Substances:

Year:  2018        PMID: 30055877     DOI: 10.1016/j.jos.2018.06.018

Source DB:  PubMed          Journal:  J Orthop Sci        ISSN: 0949-2658            Impact factor:   1.601


  7 in total

1.  Highly Porous Titanium Cups versus Hydroxyapatite-Coated Sockets: Midterm Results in Metachronous Bilateral Total Hip Arthroplasty.

Authors:  Francesco Castagnini; Barbara Bordini; Makiko Yorifuji; Federico Giardina; Simone Natali; Francesco Pardo; Francesco Traina
Journal:  Med Princ Pract       Date:  2019-05-13       Impact factor: 1.927

2.  Influence of strut-size and cell-size variations on porous Ti6Al4V structures for load-bearing implants.

Authors:  Sushant Ciliveri; Amit Bandyopadhyay
Journal:  J Mech Behav Biomed Mater       Date:  2021-12-10

3.  Impact of Acetabular Implant Design on Aseptic Failure in Total Hip Arthroplasty.

Authors:  Gloria Coden; Chelsea Matzko; Shazaan Hushmendy; William Macaulay; Matthew Hepinstall
Journal:  Arthroplast Today       Date:  2021-01-07

4.  Total hip arthroplasty using a three-dimensional porous titanium acetabular cup: an examination of micromotion using subject-specific finite element analysis.

Authors:  Takaki Miyagawa; Kazu Matsumoto; Shingo Komura; Haruhiko Akiyama
Journal:  BMC Musculoskelet Disord       Date:  2021-03-26       Impact factor: 2.362

5.  Radiographic assessment of radiolucent lines around a highly porous titanium cup (Tritanium) using digital tomosynthesis, after total hip arthroplasty.

Authors:  Kazuki Oishi; Yuji Yamamoto; Yoshifumi Harada; Ryo Inoue; Eiji Sasaki; Yasuyuki Ishibashi
Journal:  J Orthop Surg Res       Date:  2021-04-15       Impact factor: 2.359

6.  The Fate of Zone 2 Radiolucencies in Contemporary Highly Porous Acetabular Components: Not All Designs Perform Equally.

Authors:  Matthew R Zielinski; Evan R Deckard; R Michael Meneghini
Journal:  Arthroplast Today       Date:  2021-03-07

7.  In vivo evaluation of osseointegration ability of sintered bionic trabecular porous titanium alloy as artificial hip prosthesis.

Authors:  Xiaowei Bai; Ji Li; Zhidong Zhao; Qi Wang; Ningyu Lv; Yuxing Wang; Huayi Gao; Zheng Guo; Zhongli Li
Journal:  Front Bioeng Biotechnol       Date:  2022-09-14
  7 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.