| Literature DB >> 29845789 |
Zahra Ghasemi1, Nima Naderi2, Amir Shojaei1, Nooshin Ahmadirad1, Mohammad Reza Raoufy1, Javad Mirnajafi-Zadeh3.
Abstract
OBJECTIVE: Electrical low frequency stimulation (LFS) is a new therapeutic method that moderates hyperexcitability during epileptic states. Seizure occurrence is accompanied by some changes in action potential (AP) features. In this study, we investigated the inhibitory action of LFS on epileptiform activity (EA) induced-changes in AP features in hippocampal CA1 pyramidal neurons.Entities:
Keywords: Action Potential; Brain Stimulation; Hippocampus; Rat
Year: 2018 PMID: 29845789 PMCID: PMC6004994 DOI: 10.22074/cellj.2018.5443
Source DB: PubMed Journal: Cell J ISSN: 2228-5806 Impact factor: 2.479
Fig.1Representative whole cell patch clamp recordings of spontaneous firing of a CA1 pyramidal neuron induced by a 20 minutes perfusion of high potassium artificial cerebrospinal solution (high-K+ ACSF). Numbers indicate the time points in which the sample voltage traces are shown at an expanded time scale.
Fig.2Phase plot analysis of action potentials (APs). Top: AP recorded from a CA1 pyramidal neuron. Bottom: Phase plot that shows different parts of the AP presented at top.
Fig.3Different patterns of action potentials (APs) of hippocampal CA1 pyramidal neurons that appeared during epileptiform activity (EA) by high potassium artificial cerebrospinal solution (high-K+ ACSF). Left: Sample recordings of various AP patterns. Right: Relative phase plots of each voltage sample that illustrates the changes in AP features during EA.
Fig.4Effect of different pulse numbers of 1 Hz low frequency stimulation (LFS) applied at the beginning of epileptiform activity (EA) on action potentials (APs). A. Phase plot analysis that illustrates the effect of LFS on AP parameters evaluated immediately after initiation of EA, during the middle of EA, and after high potassium artificial cerebrospinal solution (high-K+ ACSF) washout and B. Effect of LFS on APs, including resting membrane potential peak amplitude, maximum rise slope, and maximum decay slope measured at three time points during EA.