Literature DB >> 29779694

The effectiveness of respiratory protection worn by communities to protect from volcanic ash inhalation. Part I: Filtration efficiency tests.

William Mueller1, Claire J Horwell2, Andrew Apsley1, Susanne Steinle1, Stephanie McPherson1, John W Cherrie3, Karen S Galea1.   

Abstract

During volcanic eruptions and their aftermath, communities may be concerned about the impacts of inhaling volcanic ash. Access to effective respiratory protection (RP) is therefore important for many people in volcanic areas all over the world. However, evidence to support the use of effective RP during such crises is currently lacking. The aim of this study was to build the first evidence base on the effectiveness of common materials used to protect communities from ash inhalation in volcanic crises. We obtained 17 forms of RP, covering various types of cloth through to disposable masks (typically used in occupational settings), which communities are known to wear during volcanic crises. The RP materials were characterised and subjected to filtration efficiency (FE) tests, which were performed with three challenge dusts: ashes from Sakurajima (Japan) and Soufrière Hills (Montserrat) volcanoes and aluminium oxide (Aloxite), chosen as a low-toxicity surrogate dust of similar particle size distribution. FE tests were conducted at two concentrations (1.5 mg/m3 and 2.5 mg/m3) and two flow rates (equivalent to 40 and 80 l/min through 15.9 cm2 sections of each RP type). Each material was held in a sample holder and PM2.5 dust concentrations were measured both outside the mask material and inside the sample holder to determine FE. A limited number of tests were undertaken to assess the effect on FE of wetting a bandana and a surgical mask, as well as folding a bandana to provide multiple filter layers. Overall, four RP materials performed very well against volcanic ash, with median FEs in excess of 98% (N95-equiv., N99-equiv., PM2.5 surgical (Japan), and Basic flat-fold (Indonesia)). The two standard surgical masks tested had median FEs of 89-91%. All other materials had median FEs ranging from 23 to 76% with no cloth materials achieving >44%. Folding a bandana resulted in better FE (40%; 3× folded) than single-layered material (29%). Wetting the bandana and surgical mask material did not improve FE overall. This first evidence base on the FE of common materials used to protect communities in volcanic crises from ash inhalation has been extended in a companion study (Steinle et al., 2018) on the total inward leakage of the best-performing masks when worn by human volunteers. This will provide a complete assessment of the effectiveness of these RP types.
Copyright © 2018 The Authors. Published by Elsevier GmbH.. All rights reserved.

Entities:  

Keywords:  Ash; Facemask; Filtration efficiency; PM(2.5); Respirator; Volcano

Mesh:

Substances:

Year:  2018        PMID: 29779694     DOI: 10.1016/j.ijheh.2018.03.012

Source DB:  PubMed          Journal:  Int J Hyg Environ Health        ISSN: 1438-4639            Impact factor:   5.840


  13 in total

1.  Qualitative fitting characteristics of filtering face-piece respirators on Iranian people.

Authors:  Anahita Fakherpour; Mehdi Jahangiri; Mozhgan Seif
Journal:  J Environ Health Sci Eng       Date:  2020-05-26

2.  Coccidioidomycosis Knowledge and Behaviors of California Hispanic Farm Workers.

Authors:  Carol L Sipan; Catherine Portillo-Silva; Heejung Bang; Stephen McCurdy
Journal:  J Agromedicine       Date:  2021-11-12       Impact factor: 1.992

3.  Can respirator face masks in a developing country reduce exposure to ambient particulate matter?

Authors:  Sasan Faridi; Ramin Nabizadeh Nodehi; Saeed Sadeghian; Masih Tajdini; Mohammad Hoseini; Masud Yunesian; Shahrokh Nazmara; Mohammad Sadegh Hassanvand; Kazem Naddafi
Journal:  J Expo Sci Environ Epidemiol       Date:  2020-04-21       Impact factor: 5.563

4.  Assessment of the Wearability of Facemasks against Air Pollution in Primary School-Aged Children in London.

Authors:  Naomi R Smart; Claire J Horwell; Trevor S Smart; Karen S Galea
Journal:  Int J Environ Res Public Health       Date:  2020-06-02       Impact factor: 3.390

5.  Optical microscopic study of surface morphology and filtering efficiency of face masks.

Authors:  Bhanu Bhakta Neupane; Sangita Mainali; Amita Sharma; Basant Giri
Journal:  PeerJ       Date:  2019-06-26       Impact factor: 2.984

6.  Factors motivating the use of respiratory protection against volcanic ashfall: A comparative analysis of communities in Japan, Indonesia and Mexico.

Authors:  Judith Covey; Claire J Horwell; Laksmi Rachmawati; Ryoichi Ogawa; Ana Lillian Martin-Del Pozzo; Maria Aurora Armienta; Fentiny Nugroho; Lena Dominelli
Journal:  Int J Disaster Risk Reduct       Date:  2019-01-16       Impact factor: 4.320

7.  Effectiveness of face masks used to protect Beijing residents against particulate air pollution.

Authors:  John W Cherrie; Andrew Apsley; Hilary Cowie; Susanne Steinle; William Mueller; Chun Lin; Claire J Horwell; Anne Sleeuwenhoek; Miranda Loh
Journal:  Occup Environ Med       Date:  2018-04-09       Impact factor: 4.402

8.  Filtration performances of non-medical materials as candidates for manufacturing facemasks and respirators.

Authors:  Weixing Hao; Andrew Parasch; Stephen Williams; Jiayu Li; Hongyan Ma; Joel Burken; Yang Wang
Journal:  Int J Hyg Environ Health       Date:  2020-07-21       Impact factor: 5.840

9.  Short Communication: Health Interventions in Volcanic Eruptions-Community Wearability Assessment of Respiratory Protection against Volcanic Ash from Mt Sinabung, Indonesia.

Authors:  Karen S Galea; Judith Covey; Sari Mutia Timur; Claire J Horwell; Fentiny Nugroho; William Mueller
Journal:  Int J Environ Res Public Health       Date:  2018-10-25       Impact factor: 3.390

10.  Occupational Respirable Mine Dust and Diesel Particulate Matter Hazard Assessment in an Underground Gold Mine in Ghana.

Authors:  Martin K Mensah; Kwadwo Mensah-Darkwa; Carsten Drebenstedt; Bright V Annam; Edward K Armah
Journal:  J Health Pollut       Date:  2020-02-28
View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.