Literature DB >> 28957696

In situ coagulation versus pre-coagulation for gravity-driven membrane bioreactor during decentralized sewage treatment: Permeability stabilization, fouling layer formation and biological activity.

An Ding1, Jinlong Wang2, Dachao Lin3, Xiaobin Tang4, Xiaoxiang Cheng5, Guibai Li6, Nanqi Ren7, Heng Liang8.   

Abstract

Gravity-driven membrane filtration systems are promising for decentralized sewage treatment due to their low energy consumption and low maintenance. However, the low stable permeability/flux is currently limiting their wider application. With the ultimate goal of increasing permeability, the aim of this study was to evaluate the effect of coagulation (in situ coagulation and pre-coagulation) on the performance of a gravity-driven membrane bioreactor (GDMBR) during treatment of synthetic sewage. Results show that in situ coagulation significantly increased permeability (more than two-fold); however, no stabilization of permeability occurred over the whole operation, when non-coagulated and pre-coagulated reactors were compared. The high permeability observed was attributed to the accumulated aluminium floc in the reactor, which prevented formation of fluorescent microbial metabolites (aromatic and tryptophan proteins, as well as fulvic acids), and further avoided membrane pore blocking. In addition, the surface porosity of the fouling layer was improved (from 11.2% to 32.4% for non-coagulated and in situ coagulated reactors). The unstable permeability was possibly associated with lower biological processes within the fouling layer. These might include lower adenosine triphosphate (ATP) content and lower fluorescent metabolites from the extracellular polymeric substances (EPS) caused by the accumulated Al (compared with the control). On the other hand, pre-coagulation improved the level of stable permeability compared with the control (80 versus 40 L/m2 h bar), mainly because pre-coagulation decreased the EPS content and also maintained high ATP content of the fouling layer. In addition, both coagulation processes reduced the total filtration resistance, mainly the hydraulically reversible resistance and cake layer resistance, which could lower the cleaning frequency. Overall, coagulation could greatly increase the removal efficiency and improve the GDMBR permeability, which would make the process suitable for decentralized wastewater treatment.
Copyright © 2017 Elsevier Ltd. All rights reserved.

Entities:  

Keywords:  Bio-fouling layer; Biological activity; Coagulation; EPS; GDM; Permeability

Mesh:

Substances:

Year:  2017        PMID: 28957696     DOI: 10.1016/j.watres.2017.09.027

Source DB:  PubMed          Journal:  Water Res        ISSN: 0043-1354            Impact factor:   11.236


  3 in total

1.  Deep Learning Target Detection System for Sewage Treatment.

Authors:  Bingqin Su; Yuting Lin; Jian Wang; Xiaohui Quan; Zhankun Chang; Chuangxue Rui
Journal:  Comput Intell Neurosci       Date:  2022-07-05

2.  Fabrication of Tween-20 coated PVDF membranes for wastewater treatment: optimization of preparation parameters, removal and membrane fouling control performance.

Authors:  Daoji Wu; Weiwei Zhou; Xiaoxiang Cheng; Congwei Luo; Peijie Li; Fengzhi Zhang; Zixiao Ren
Journal:  RSC Adv       Date:  2019-06-27       Impact factor: 4.036

3.  Gravity-Driven Membrane Reactor for Decentralized Wastewater Treatment: Effect of Reactor Configuration and Cleaning Protocol.

Authors:  Ihtisham Ul Haq Shami; Bing Wu
Journal:  Membranes (Basel)       Date:  2021-05-25
  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.