Literature DB >> 28360121

Prosthetic model, but not stiffness or height, affects the metabolic cost of running for athletes with unilateral transtibial amputations.

Owen N Beck1, Paolo Taboga2, Alena M Grabowski2,3.   

Abstract

Running-specific prostheses enable athletes with lower limb amputations to run by emulating the spring-like function of biological legs. Current prosthetic stiffness and height recommendations aim to mitigate kinematic asymmetries for athletes with unilateral transtibial amputations. However, it is unclear how different prosthetic configurations influence the biomechanics and metabolic cost of running. Consequently, we investigated how prosthetic model, stiffness, and height affect the biomechanics and metabolic cost of running. Ten athletes with unilateral transtibial amputations each performed 15 running trials at 2.5 or 3.0 m/s while we measured ground reaction forces and metabolic rates. Athletes ran using three different prosthetic models with five different stiffness category and height combinations per model. Use of an Ottobock 1E90 Sprinter prosthesis reduced metabolic cost by 4.3 and 3.4% compared with use of Freedom Innovations Catapult [fixed effect (β) = -0.177; P < 0.001] and Össur Flex-Run (β = -0.139; P = 0.002) prostheses, respectively. Neither prosthetic stiffness (P ≥ 0.180) nor height (P = 0.062) affected the metabolic cost of running. The metabolic cost of running was related to lower peak (β = 0.649; P = 0.001) and stance average (β = 0.772; P = 0.018) vertical ground reaction forces, prolonged ground contact times (β = -4.349; P = 0.012), and decreased leg stiffness (β = 0.071; P < 0.001) averaged from both legs. Metabolic cost was reduced with more symmetric peak vertical ground reaction forces (β = 0.007; P = 0.003) but was unrelated to stride kinematic symmetry (P ≥ 0.636). Therefore, prosthetic recommendations based on symmetric stride kinematics do not necessarily minimize the metabolic cost of running. Instead, an optimal prosthetic model, which improves overall biomechanics, minimizes the metabolic cost of running for athletes with unilateral transtibial amputations.NEW &amp; NOTEWORTHY The metabolic cost of running for athletes with unilateral transtibial amputations depends on prosthetic model and is associated with lower peak and stance average vertical ground reaction forces, longer contact times, and reduced leg stiffness. Metabolic cost is unrelated to prosthetic stiffness, height, and stride kinematic symmetry. Unlike nonamputees who decrease leg stiffness with increased in-series surface stiffness, biological limb stiffness for athletes with unilateral transtibial amputations is positively correlated with increased in-series (prosthetic) stiffness.

Entities:  

Keywords:  amputee; asymmetry; prosthesis

Mesh:

Year:  2017        PMID: 28360121     DOI: 10.1152/japplphysiol.00896.2016

Source DB:  PubMed          Journal:  J Appl Physiol (1985)        ISSN: 0161-7567


  9 in total

1.  How do prosthetic stiffness, height and running speed affect the biomechanics of athletes with bilateral transtibial amputations?

Authors:  Owen N Beck; Paolo Taboga; Alena M Grabowski
Journal:  J R Soc Interface       Date:  2017-06       Impact factor: 4.118

2.  Step time asymmetry increases metabolic energy expenditure during running.

Authors:  Owen N Beck; Eric N Azua; Alena M Grabowski
Journal:  Eur J Appl Physiol       Date:  2018-07-19       Impact factor: 3.078

3.  Added lower limb mass does not affect biomechanical asymmetry but increases metabolic power in runners with a unilateral transtibial amputation.

Authors:  Ryan S Alcantara; Owen N Beck; Alena M Grabowski
Journal:  Eur J Appl Physiol       Date:  2020-04-28       Impact factor: 3.078

4.  Running-specific prosthesis model, stiffness and height affect biomechanics and asymmetry of athletes with unilateral leg amputations across speeds.

Authors:  Joshua R Tacca; Owen N Beck; Paolo Taboga; Alena M Grabowski
Journal:  R Soc Open Sci       Date:  2022-06-01       Impact factor: 3.653

5.  Prosthetic shape, but not stiffness or height, affects the maximum speed of sprinters with bilateral transtibial amputations.

Authors:  Paolo Taboga; Owen N Beck; Alena M Grabowski
Journal:  PLoS One       Date:  2020-02-20       Impact factor: 3.240

6.  Shortcomings of human-in-the-loop optimization of an ankle-foot prosthesis emulator: a case series.

Authors:  Cara Gonzalez Welker; Alexandra S Voloshina; Vincent L Chiu; Steven H Collins
Journal:  R Soc Open Sci       Date:  2021-05-05       Impact factor: 2.963

7.  External Mechanical Work in Runners With Unilateral Transfemoral Amputation.

Authors:  Hiroto Murata; Genki Hisano; Daisuke Ichimura; Hiroshi Takemura; Hiroaki Hobara
Journal:  Front Bioeng Biotechnol       Date:  2021-12-27

8.  Control Framework for Sloped Walking With a Powered Transfemoral Prosthesis.

Authors:  Namita Anil Kumar; Shawanee Patrick; Woolim Hong; Pilwon Hur
Journal:  Front Neurorobot       Date:  2022-01-11       Impact factor: 2.650

9.  Prosthetic model, but not stiffness or height, affects maximum running velocity in athletes with unilateral transtibial amputations.

Authors:  Paolo Taboga; Emily K Drees; Owen N Beck; Alena M Grabowski
Journal:  Sci Rep       Date:  2020-02-04       Impact factor: 4.379

  9 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.