INTRODUCTION: Indirect composites are developed to overcome the shortcomings of direct composites but, the adhesion of resin cements to indirect composites is still difficult. The purpose of this study was to evaluate the surface morphology of indirect resin composite treated by different powers of Er:YAG laser using Scanning Electron Microscopy (SEM). METHODS: indirect resin composite blocks (GC Gradia DA2, Japan) with 15× 10 × 10 mm dimensions were made according to manufacturer's instructions (n=7). The bonding surface of these blocks were polished, then the samples were divided to seven groups as follow: Erbium-Doped Yttrium Aluminum Garnet (Er:YAG)laser with output power of 2, 3, 4, 5, 6,7 W (frequency of 20 Hz, very short pulse) and no treatment. Then, the surfaces were evaluated by scanning electron microscope. RESULTS: The surface treated by Er:YAG laser showed a porous surface. But the amount and pattern of these irregularities differ in each group which may produce micromechanical retention compared to control group with no treatment. CONCLUSION: Er:YAG laser can be used as an alternative technique for surface treatment and roughening of indirect resin composites.
INTRODUCTION: Indirect composites are developed to overcome the shortcomings of direct composites but, the adhesion of resin cements to indirect composites is still difficult. The purpose of this study was to evaluate the surface morphology of indirect resin composite treated by different powers of Er:YAG laser using Scanning Electron Microscopy (SEM). METHODS: indirect resin composite blocks (GC Gradia DA2, Japan) with 15× 10 × 10 mm dimensions were made according to manufacturer's instructions (n=7). The bonding surface of these blocks were polished, then the samples were divided to seven groups as follow: Erbium-Doped Yttrium Aluminum Garnet (Er:YAG)laser with output power of 2, 3, 4, 5, 6,7 W (frequency of 20 Hz, very short pulse) and no treatment. Then, the surfaces were evaluated by scanning electron microscope. RESULTS: The surface treated by Er:YAG laser showed a porous surface. But the amount and pattern of these irregularities differ in each group which may produce micromechanical retention compared to control group with no treatment. CONCLUSION: Er:YAG laser can be used as an alternative technique for surface treatment and roughening of indirect resin composites.
Authors: Marco Aurélio Veiga de Melo; Marcos Ribeiro Moysés; Saulo Galvão dos Santos; Carlos Eduardo Pinto Alcântara; José Carlos Rabelo Ribeiro Journal: Braz Oral Res Date: 2011 Nov-Dec
Authors: Simone G Moretto; Nilton Azambuja; Victor E Arana-Chavez; Andre F Reis; Marcelo Giannini; Carlos de P Eduardo; Patricia M De Freitas Journal: Microsc Res Tech Date: 2010-10-13 Impact factor: 2.769