Arno Bisschop1, Susanne J P M van Engelen2, Idsart Kingma2, Roderick M Holewijn3, Agnita Stadhouder3, Albert J van der Veen4, Jaap H van Dieën5, Barend J van Royen6. 1. Department of Orthopaedic Surgery, Research Institute MOVE, VU University Medical Center, De Boelelaan 1117, 1081 HV Amsterdam, The Netherlands. Electronic address: a.bisschop@vumc.nl. 2. Research Institute MOVE, Faculty of Human Movement Sciences, VU University, Amsterdam, The Netherlands. 3. Department of Orthopaedic Surgery, Research Institute MOVE, VU University Medical Center, De Boelelaan 1117, 1081 HV Amsterdam, The Netherlands. 4. Department of Physics and Medical Technology, VU University Medical Center, The Netherlands. 5. Research Institute MOVE, Faculty of Human Movement Sciences, VU University, Amsterdam, The Netherlands; Department of Biomedical Engineering, King Abdulaziz University, Saudi Arabia. 6. Department of Orthopaedic Surgery, Research Institute MOVE, VU University Medical Center, De Boelelaan 1117, 1081 HV Amsterdam, The Netherlands. Electronic address: bj.vanroyen@vumc.nl.
Abstract
BACKGROUND: Degenerative lumbar spinal stenosis causes neurological symptoms due to neural compression. Lumbar laminectomy is a commonly used treatment for symptomatic degenerative spinal stenosis. However, it is unknown if and to what extent single level laminectomy affects the range of motion and stiffness of treated and adjacent segments. An increase in range of motion and a decrease in stiffness are possible predictors of post-operative spondylolisthesis or spinal failure. METHODS: Twelve cadaveric human lumbar spines were obtained. After preloading, spines were tested in flexion-extension, lateral bending, and axial rotation. Subsequently, single level lumbar laminectomy analogous to clinical practice was performed at level lumbar 2 or 4. Thereafter, load-deformation tests were repeated. The range of motion and stiffness of treated and adjacent segments were calculated before and after laminectomy. Untreated segments were used as control group. Effects of laminectomy on stiffness and range of motion were tested, separately for treated, adjacent and control segments, using repeated measures analysis of variance. FINDINGS: Range of motion at the level of laminectomy increased significantly for flexion and extension (7.3%), lateral bending (7.5%), and axial rotation (12.2%). Range of motion of adjacent segments was only significantly affected in lateral bending (-7.7%). Stiffness was not affected by laminectomy. INTERPRETATION: The increase in range of motion of 7-12% does not seem to indicate the use of additional instrumentation to stabilize the lumbar spine. If instrumentation is still considered in a patient, its primary focus should be on re-stabilizing only the treated segment level.
BACKGROUND: Degenerative lumbar spinal stenosis causes neurological symptoms due to neural compression. Lumbar laminectomy is a commonly used treatment for symptomatic degenerative spinal stenosis. However, it is unknown if and to what extent single level laminectomy affects the range of motion and stiffness of treated and adjacent segments. An increase in range of motion and a decrease in stiffness are possible predictors of post-operative spondylolisthesis or spinal failure. METHODS: Twelve cadaveric human lumbar spines were obtained. After preloading, spines were tested in flexion-extension, lateral bending, and axial rotation. Subsequently, single level lumbar laminectomy analogous to clinical practice was performed at level lumbar 2 or 4. Thereafter, load-deformation tests were repeated. The range of motion and stiffness of treated and adjacent segments were calculated before and after laminectomy. Untreated segments were used as control group. Effects of laminectomy on stiffness and range of motion were tested, separately for treated, adjacent and control segments, using repeated measures analysis of variance. FINDINGS: Range of motion at the level of laminectomy increased significantly for flexion and extension (7.3%), lateral bending (7.5%), and axial rotation (12.2%). Range of motion of adjacent segments was only significantly affected in lateral bending (-7.7%). Stiffness was not affected by laminectomy. INTERPRETATION: The increase in range of motion of 7-12% does not seem to indicate the use of additional instrumentation to stabilize the lumbar spine. If instrumentation is still considered in a patient, its primary focus should be on re-stabilizing only the treated segment level.
Authors: Michael T Nolte; Philip K Louie; Bryce A Basques; Arya G Varthi; Justin C Paul; Krishn Khanna; Tarush Khurana; Arshan Chaudhri; Dino Samartzis; Edward J Goldberg; Howard S An Journal: Int J Spine Surg Date: 2021-09-22
Authors: Matthew Wheelwright; Paige J Selvey; Paul Steinbok; Ash Singhal; George Ibrahim; Aria Fallah; Alexander G Weil; Kyle Halvorson; Albert Tu Journal: Childs Nerv Syst Date: 2019-10-08 Impact factor: 1.475
Authors: Arno Bisschop; Roderick M Holewijn; Idsart Kingma; Agnita Stadhouder; Pieter-Paul A Vergroesen; Albert J van der Veen; Jaap H van Dieën; Barend J van Royen Journal: Global Spine J Date: 2014-11-06
Authors: Roderick M Holewijn; Marinus de Kleuver; Albert J van der Veen; Kaj S Emanuel; Arno Bisschop; Agnita Stadhouder; Barend J van Royen; Idsart Kingma Journal: Global Spine J Date: 2017-04-07