Electrostatic effects in asbestos sampling. I: Experimental measurements.

Electrostatic charge can cause errors during sampling of airborne asbestos fibers and other particles. The change in particle trajectories caused by charge effects during sampling can result in nonuniform deposits on the collecting filter surface and net loss of sample. The degree of these electrostatic effects depends on particle charge, sampler charge, sampler conductivity, and sampling flow rate and direction. The purpose of this research was to evaluate the dependence of sampling efficiency and sample uniformity on these variables. Humidity has been postulated as a primary determinant of particle charge during aerosol generation. Measurements of particle charge and concentration were made as a function of relative humidity with chrysotile fibers generated from a fluidized bed. A strong increase in charge and a decrease in concentration of fibers was noted as the relative humidity was decreased below 15%. The effects of conductive versus nonconductive samplers and sampling flow rate were measured as a function of particle and sampler charge levels. Nonconductive samplers can carry a large and variable charge distribution on their surfaces. This can result in a biased and highly variable particle deposit on the filter when sampling charged particles. Conductive cowls spread any acquired charge over the entire surface and produce a more symmetrical and less biased charged particle deposit. Increasing the sampling flow rate will improve sampling efficiency and decrease deposit variability because the charged particle has less time to interact with the field produced by the sampler. These results suggest that sampling problems caused by electrostatic charge interactions are most likely to occur under low humidity conditions of dust generation, that sampling should be done at as high a flow rate as possible to reduce these effects, and that analysts should select fields toward the center of the filter to minimize bias and variability.