Effects of different polishing methods on color stability of resin composites after accelerated aging.

The purpose of this study was to evaluate the effect of polishing procedures on the color stability of different types of composites after aging. Forty disk-shaped specimens (Ø10×2 mm) were prepared for each composite resin type (an ormocer, a packable, a nanohybrid, and a microhybrid) for a total of 160 specimens. Each composite group was divided into four subgroups according to polishing method (n=10): control (no finishing and polishing), polishing disk, polishing wheel, and glaze material. Color parameters (L*, a*, and b*) and surface roughness were measured before and after accelerated aging. Of the polishing methods, glazed specimens showed the lowest color change (∆E*), ∆L*, and ∆b* values (p<0.05). Of the composite resins, the microhybrid composite showed the lowest ∆E* value, whereas the ormocer showed the highest (p<0.05). For all composite types, the surface roughness of their control groups decreased after aging (p<0.05). In conclusion, all composite resins showed color changes after accelerated aging, with the use of glaze material resulting in the lowest color change.