Factors affecting the estimation of physical working capacity at the fatigue threshold.

The purpose of this study was to investigate potential improvements in the methodology associated with the Physical Working Capacity at the Fatigue Threshold (PWCFT) test including: (1) the use of a continuous test protocol; (2) the use of a treadmill; (3) the use of a bipolar EMG lead system for noisy electronic environments; and (4) the potential for residual fatigue from tests repeated 24 hours apart. The results of the continuous test protocol (mean +/- S.D. = 210 +/- 73 watts) correlated well (r = 0.856) with the original discontinuous technique (222 +/- 83 watts) and there was no significant (p greater than 0.05) difference between the mean values (t = 1.146). Treadmill testing required a bipolar lead system to counteract the electrical noise generated by the treadmill motor. The heart rate values which corresponded to PWCFT on the treadmill (mean +/- s.d. = 164 +/- b.p.m.) and bicycle ergometer (153 +/- 18 b.p.m.) were highly correlated (r = 0.833) and there was no significant (p greater than 0.05) difference between the mean values (t = 2.22). The use of a bipolar lead EMG system on the bicycle ergometer resulted in significantly (p less than 0.05) smaller voltage for any given power output, and the PWCFT exhibited a low to moderate correlation (r = 0.60) with PWCFT derived from a unipolar arrangement. The test-retest results of discontinuous PWCFT measurements performed 24 hours apart on the bicycle ergometer were correlated at r = 0.812 with no significant (p greater than 0.05) difference (t = 0.52) between the mean values (test = 198 +/- 60; retest = 191 +/- 63 watts).(ABSTRACT TRUNCATED AT 250 WORDS)