| Literature DB >> 22754632 |
Christina Thiede, Vladimir Fridman, Adina Gerson-Gurwitz, Larisa Gheber, Christoph F Schmidt.
Abstract
Kinesin-5 mechanoenzymes drive mitotic spindle dynamics as slow, processive microtubule (MT)-plus-end directed motors. Surprisingly, the Saccharomyces cerevisiae kinesin-5 Cin8 was recently found to be bi-directional: it can move processively in both directions on MTs. Two hypotheses have been suggested for the mechanism of the directionality switch: (1) single molecules of Cin8 are intrinsically minus-end directed, but mechanical coupling between two or more motors triggers the switch; (2) a single motor can switch direction, and "cargo binding" i.e., binding between two MTs triggers the switch to plus-end motility. Single-molecule fluorescence data we published recently, and augment here, favor hypothesis (2). In low-ionic-strength conditions, single molecules of Cin8 move in both minus- and plus-end directions. Fluorescence photo bleaching data rule out aggregation of Cin8 while they move in the plus and in the minus direction. The evidence thus points toward cargo regulation of directionality, which is likely to be related to cargo regulation in other kinesins. The molecular mechanisms of this regulation, however, remain to be elucidated.Entities:
Year: 2012 PMID: 22754632 PMCID: PMC3383724 DOI: 10.4161/bioa.20395
Source DB: PubMed Journal: Bioarchitecture ISSN: 1949-0992

Figure 1. In low-ionic-strength conditions, single Cin8 motors move toward the plus end of MTs. (A) Kymographs of Cin8 moving away from the brightly labeled seed marking the minus end (-) toward the plus end (+) of the MT. Kymograph in the right bottom panel was captured in MB-30; the other two in MB-0 (exact buffer compositions are given below). Scale bars: horizontal: 10 sec; vertical: 3 µm. (B) Exemplary intensity traces of two motors landing on a MT and moving to the MT plus end (black and red) and of a motor landing on a MT and remaining immobile (green). The traces of the moving motors correspond to the two events shown in the left panel of (A). (C) Histogram of fluorescence intensities before and after final bleaching steps of immobile motors, summed from a 800 nm × 800 nm square of camera pixels containing the image of the motor (number of traces /motors: 8). A sum of two Gaussians was fitted to the histogram. The first narrower peak corresponds to the background [compare also to (B)]. The broader second peak represents the intensity of a single GFP. (D) Histogram of initial intensities of Cin8 molecules right after landing, measured in the same arbitrary units as in (C). The intensity of the first three frames (1.5 sec) after landing was averaged for both moving and immobile motors. The histogram has a maximum at 4 times the intensity of a single GFP [compare with (C)]. Materials and Methods: Single-molecule fluorescence assays were performed as described in detail in Gerson-Gurwitz et al. In short, the custom-built total-internal-reflection-fluorescence (TIRF) microscope consisted of a 473 nm laser (Viasho, USA) for excitation, a 100x objective (SFluor, NA 1.49, oil, Nikon, USA), and a CCD camera (Cascade 512B, Roper Scientific, USA) for detection. To observe several colors simultaneously, the fluorescence emission signal was split by dichroic mirrors and directed to separate areas on the CCD camera. Fluorescently Cin8-TEV-GFP-6HIS was overexpressed in S. cerevisiae and affinity purified using the his-tag and a Ni-NTA affinity column (Invitrogen, USA). The low-salt buffers for the motility assays were composed as follows: MB-0: 50 mM Tris/HCl, 30 mM PIPES/KOH, pH 7.2, 2 mM EDTA, 1 mM EGTA, 10% glycerol, 1 mM phenylmethylsulfonyl fluoride and 1 mM dithiothreitol. MB-30: the same as MB-0 but with 30 mM added NaCl. MTs were polymerized from tissue-purified porcine tubulin, essentially as described before, but with Atto-488 (Atto-Tec GmbH, Siegen, Germany) labeled seeds that also fluoresce in the green and in that way mark the minus end of the MTs. Kymographs were generated and analyzed with a custom-written LabView (National Instruments, USA) routine. The fluorescence intensity emitted by single proteins was summed over an area of 5 × 5 camera pixels, corresponding to an area of 800 nm × 800 nm in the specimen plane and was analyzed with ImageJ software (NIH, USA), and histograms and fits were done with OriginPro software (OriginLab Corporation, USA).

Figure 2. Proposed model for the directionality switch of Cin8. A microtubule is sketched in light blue, with plus and minus end indicated; Cin8 is shown in green; catalytic motor domain and coiled-coil regions are indicated in the legend. Arrows indicate the direction of movement of Cin8 on the MT to which it is attached. (A) On a single MT, in high-ionic-strength conditions, Cin8 is minus-end directed. Binding between two antiparallel MTs activates Cin8 to move in the plus-end directions of the MTs, causing their antiparallel sliding. (B) Under low-ionic-strength conditions on a single MT, a modified interaction between tails and catalytic domains or flexing of the whole tetramer triggers Cin8 to move in the plus-end direction of the MT. If the tetramer can flex enough, plus-end directed motility of single molecules of Cin8 could be triggered by binding of the two heads of Cin8 to the same MT.