Literature DB >> 22673809

Solid-phase extraction combined with large volume injection-programmable temperature vaporization-gas chromatography-mass spectrometry for the multiresidue determination of priority and emerging organic pollutants in wastewater.

E Bizkarguenaga1, O Ros, A Iparraguirre, P Navarro, A Vallejo, A Usobiaga, O Zuloaga.   

Abstract

In the present work the simultaneous extraction for the multiresidue determination in wastewater samples of organic compounds such as polychlorinated biphenyls (PCBs), polybrominated biphenyls (PBBs), pesticides, polycyclic aromatic hydrocarbons (PAHs), phthalate esters (PEs), alkylphenols (APs), bisphenol A (BPA) or hormones included in different lists of priority and emerging pollutants because of their action as endocrine disrupting compounds (EDCs) was developed. Different solid phase extraction (SPE) variables such as the nature of the solid phase (Oasis-HLC, C18 and Lichrolut), the sample volume, the addition of MeOH and NaCl, the pH of the water phase and the volume of the eluent solvent were optimized in order to analyze simultaneously the priority and emerging families of pollutants mentioned above. Good recoveries were obtained for Milli-Q water (80-120%), however, since the use of deuterated analogues and dilution of the sample did not correct the matrix effect, additional SPE clean-up step using Florisil® cartridges was necessary to obtain good results for wastewater samples (80-125%). In order to improve the limits of detection (LODs), large volume injection (LVI) using programmable temperature vaporizer (PTV) coupled to gas chromatography-mass spectrometry (GC-MS) was also optimized. Since analytes losses in the case of the most volatile congeners occurred during the derivatization step and no separation of the derivatized and the non-derivatized analytes was possible during SPE elution, two different injections were optimized for each analyte group. LODs were in good agreement with those found in the literature and relative standard deviations (RSDs) were in the 10-25% range for Milli-Q and 12-30% for wastewater samples. The method was finally applied to the determination of target analytes in three different wastewater treatment plants (WWTPs, Bakio, Gernika and Galindo (Spain)) and in one water purification plant (WPP) in Zornotza (Spain).
Copyright © 2012 Elsevier B.V. All rights reserved.

Entities:  

Mesh:

Substances:

Year:  2012        PMID: 22673809     DOI: 10.1016/j.chroma.2012.05.022

Source DB:  PubMed          Journal:  J Chromatogr A        ISSN: 0021-9673            Impact factor:   4.759


  4 in total

1.  Assessment of commercially available polymeric materials for sorptive microextraction of priority and emerging nonpolar organic pollutants in environmental water samples.

Authors:  Laura Blanco-Zubiaguirre; Alejandra Delgado; Oihana Ros; Oscar Posada-Ureta; Asier Vallejo; Ailette Prieto; Maitane Olivares; Nestor Etxebarria
Journal:  Environ Sci Pollut Res Int       Date:  2014-01-15       Impact factor: 4.223

Review 2.  Meta-analysis of environmental contamination by phthalates.

Authors:  Alexandre Bergé; Mathieu Cladière; Johnny Gasperi; Annie Coursimault; Bruno Tassin; Régis Moilleron
Journal:  Environ Sci Pollut Res Int       Date:  2013-08-06       Impact factor: 4.223

3.  Modeling the physisorption of bisphenol A on graphene and graphene oxide.

Authors:  Diego Cortés-Arriagada; Luis Sanhueza; Mireya Santander-Nelli
Journal:  J Mol Model       Date:  2013-05-31       Impact factor: 1.810

Review 4.  Dual-Functional Monomer MIPs and Their Comparison to Mono-Functional Monomer MIPs for SPE and as Sensors.

Authors:  Angela Alysia Elaine; Steven Imanuel Krisyanto; Aliya Nur Hasanah
Journal:  Polymers (Basel)       Date:  2022-08-26       Impact factor: 4.967

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.