Literature DB >> 22154860

Effect of cleaning and sterilization on titanium implant surface properties and cellular response.

Jung Hwa Park1, Rene Olivares-Navarrete, Robert E Baier, Anne E Meyer, Rina Tannenbaum, Barbara D Boyan, Zvi Schwartz.   

Abstract

Titanium (Ti) has been widely used as an implant material due to the excellent biocompatibility and corrosion resistance of its oxide surface. Biomaterials must be sterile before implantation, but the effects of sterilization on their surface properties have been less well studied. The effects of cleaning and sterilization on surface characteristics were bio-determined using contaminated and pure Ti substrata first manufactured to present two different surface structures: pretreated titanium (PT, Ra=0.4 μm) (i.e. surfaces that were not modified by sandblasting and/or acid etching); (SLA, Ra=3.4 μm). Previously cultured cells and associated extracellular matrix were removed from all bio-contaminated specimens by cleaning in a sonicator bath with a sequential acetone-isopropanol-ethanol-distilled water protocol. Cleaned specimens were sterilized with autoclave, gamma irradiation, oxygen plasma, or ultraviolet light. X-ray photoelectron spectroscopy (XPS), contact angle measurements, profilometry, and scanning electron microscopy were used to examine surface chemical components, hydrophilicity, roughness, and morphology, respectively. Small organic molecules present on contaminated Ti surfaces were removed with cleaning. XPS analysis confirmed that surface chemistry was altered by both cleaning and sterilization. Cleaning and sterilization affected hydrophobicity and roughness. These modified surface properties affected osteogenic differentiation of human MG63 osteoblast-like cells. Specifically, autoclaved SLA surfaces lost the characteristic increase in osteoblast differentiation seen on starting SLA surfaces, which was correlated with altered surface wettability and roughness. These data indicated that recleaned and resterilized Ti implant surfaces cannot be considered the same as the first surfaces in terms of surface properties and cell responses. Therefore, the reuse of Ti implants after resterilization may not result in the same tissue responses as found with never-before-implanted specimens.
Copyright © 2011 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Entities:  

Mesh:

Year:  2011        PMID: 22154860      PMCID: PMC3618465          DOI: 10.1016/j.actbio.2011.11.026

Source DB:  PubMed          Journal:  Acta Biomater        ISSN: 1742-7061            Impact factor:   8.947


  28 in total

1.  Characterization of sterilized CP titanium implant surfaces.

Authors:  J C Keller; R A Draughn; J P Wightman; W J Dougherty; S D Meletiou
Journal:  Int J Oral Maxillofac Implants       Date:  1990       Impact factor: 2.804

2.  Characterization of Bacillus subtilis spore inactivation in low-pressure, low-temperature gas plasma sterilization processes.

Authors:  S Roth; J Feichtinger; C Hertel
Journal:  J Appl Microbiol       Date:  2009-06-30       Impact factor: 3.772

3.  Dynamic sterilization of titanium implants with ultraviolet light.

Authors:  S Singh; N G Schaaf
Journal:  Int J Oral Maxillofac Implants       Date:  1989       Impact factor: 2.804

4.  Dental implant materials. II. Preparative procedures and surface spectroscopic studies.

Authors:  D C Smith; R M Pilliar; J B Metson; N S McIntyre
Journal:  J Biomed Mater Res       Date:  1991-09

5.  Dental implant materials. I. Some effects of preparative procedures on surface topography.

Authors:  D C Smith; R M Pilliar; R Chernecky
Journal:  J Biomed Mater Res       Date:  1991-09

6.  Surface analysis of titanium after sterilization: role in implant-tissue interface and bioadhesion.

Authors:  J H Doundoulakis
Journal:  J Prosthet Dent       Date:  1987-10       Impact factor: 3.426

7.  Biomaterial and implant surfaces: on the role of cleanliness, contamination, and preparation procedures.

Authors:  B Kasemo; J Lausmaa
Journal:  J Biomed Mater Res       Date:  1988-08

8.  Degradative effects of conventional steam sterilization on biomaterial surfaces.

Authors:  R E Baier; A E Meyer; C K Akers; J R Natiella; M Meenaghan; J M Carter
Journal:  Biomaterials       Date:  1982-10       Impact factor: 12.479

9.  Accelerated oxide growth on titanium implants during autoclaving caused by fluorine contamination.

Authors:  J Lausmaa; B Kasemo; S Hansson
Journal:  Biomaterials       Date:  1985-01       Impact factor: 12.479

10.  Influence of sterilization on the mineralization of titanium implants induced by incubation in various biological model fluids.

Authors:  A P Serro; B Saramago
Journal:  Biomaterials       Date:  2003-11       Impact factor: 12.479

View more
  36 in total

1.  Effects of different sterilization methods on surface characteristics and biofilm formation on zirconia in vitro.

Authors:  Aifang Han; James K H Tsoi; Jukka P Matinlinna; Yu Zhang; Zhuofan Chen
Journal:  Dent Mater       Date:  2017-11-26       Impact factor: 5.304

2.  Effects of EGF-coated titanium surfaces on adhesion and metabolism of bisphosphonate-treated human keratinocytes and gingival fibroblasts.

Authors:  Taisa Nogueira Pansani; Laís Medeiros Cardoso; Luisa Ammirabile Augusto; Isabela Massaro Ribeiro; Carlos Alberto de Souza Costa; Fernanda Gonçalves Basso
Journal:  Clin Oral Investig       Date:  2021-04-14       Impact factor: 3.573

3.  The roles of titanium surface micro/nanotopography and wettability on the differential response of human osteoblast lineage cells.

Authors:  Rolando A Gittens; Rene Olivares-Navarrete; Alice Cheng; David M Anderson; Taylor McLachlan; Ingrid Stephan; Jürgen Geis-Gerstorfer; Kenneth H Sandhage; Andrei G Fedorov; Frank Rupp; Barbara D Boyan; Rina Tannenbaum; Zvi Schwartz
Journal:  Acta Biomater       Date:  2012-12-08       Impact factor: 8.947

4.  Use of polyelectrolyte thin films to modulate osteoblast response to microstructured titanium surfaces.

Authors:  Jung Hwa Park; Rene Olivares-Navarrete; Christine E Wasilewski; Barbara D Boyan; Rina Tannenbaum; Zvi Schwartz
Journal:  Biomaterials       Date:  2012-04-27       Impact factor: 12.479

5.  Development and biological evaluation of fluorophosphonate-modified hydroxyapatite for orthopaedic applications.

Authors:  Gráinne Neary; Ashley W Blom; Anna I Shiel; Gabrielle Wheway; Jason P Mansell
Journal:  J Mater Sci Mater Med       Date:  2018-07-21       Impact factor: 3.896

6.  The responses to surface wettability gradients induced by chitosan nanofilms on microtextured titanium mediated by specific integrin receptors.

Authors:  Jung Hwa Park; Christine E Wasilewski; Noelia Almodovar; Rene Olivares-Navarrete; Barbara D Boyan; Rina Tannenbaum; Zvi Schwartz
Journal:  Biomaterials       Date:  2012-07-24       Impact factor: 12.479

7.  Low power gas discharge plasma mediated inactivation and removal of biofilms formed on biomaterials.

Authors:  Christian Traba; Long Chen; Jun F Liang
Journal:  Curr Appl Phys       Date:  2013-03-20       Impact factor: 2.480

8.  Role of integrin α2 β1 in mediating osteoblastic differentiation on three-dimensional titanium scaffolds with submicron-scale texture.

Authors:  Xiaokun Wang; Zvi Schwartz; Rolando A Gittens; Alice Cheng; Rene Olivares-Navarrete; Haifeng Chen; Barbara D Boyan
Journal:  J Biomed Mater Res A       Date:  2014-09-16       Impact factor: 4.396

9.  The stability of BMP loaded polyelectrolyte multilayer coatings on titanium.

Authors:  Raphael Guillot; Flora Gilde; Pierre Becquart; Frédéric Sailhan; Aurélien Lapeyrere; Delphine Logeart-Avramoglou; Catherine Picart
Journal:  Biomaterials       Date:  2013-05-02       Impact factor: 12.479

Review 10.  A review on the wettability of dental implant surfaces II: Biological and clinical aspects.

Authors:  Rolando A Gittens; Lutz Scheideler; Frank Rupp; Sharon L Hyzy; Jürgen Geis-Gerstorfer; Zvi Schwartz; Barbara D Boyan
Journal:  Acta Biomater       Date:  2014-04-05       Impact factor: 8.947

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.