Literature DB >> 22040694

Accuracy of in situ neck-shaft angle and shortening measurements of the anatomically reduced, varus malreduced and shortened proximal femur: can we believe what we see on the postoperative films?

Meir Marmor1, Christopher Nystuen, Nathan Ehemer, R Trigg McClellan, Amir Matityahu.   

Abstract

OBJECTIVES: Measuring the neck-shaft angle (NSA) and amount of shortening of the femoral neck on the anterior to posterior (AP) X-ray is important when treating proximal femur fractures. To compensate for proximal femoral external rotation, the X-rays need to be taken with the leg internally rotated, an act that cannot always be performed or verified. This study aims to define the utility of in situ AP X-ray in NSA and shortening measurements.
METHODS: Computed tomography (CT) scans of 50 patients undergoing abdominal CT scans were assessed for the in situ rotation of the femoral neck relative to the AP beam. Three proximal femur fracture Sawbones models were made and AP X-rays of the models were taken with changing proximal femur rotation. NSA and shortening were measured on all X-rays.
RESULTS: In situ femoral neck rotation averaged 25.4±10.6° of external rotation (range, 0.9-51.8°, 80% of measurements less than 35°). NSA measurements varied less than 5° with less than 35° of rotation in all models, and were always greater than the true value. Femoral neck vertical length (VL) measurement was independent of proximal femur rotation whereas the horizontal length component was found to be highly dependent on the same.
CONCLUSIONS: NSA measured on AP X-ray will be accurate to within 5° in 80% of patients with the hip left in situ and in 100% of the patients if the hip is internally rotated 15°. Measurement of significant varus or loss of VL of the femoral neck can be considered accurate regardless of leg rotation at the time of X-rays being taken.
Copyright © 2011 Elsevier Ltd. All rights reserved.

Entities:  

Mesh:

Year:  2011        PMID: 22040694     DOI: 10.1016/j.injury.2011.10.010

Source DB:  PubMed          Journal:  Injury        ISSN: 0020-1383            Impact factor:   2.586


  3 in total

1.  Tip apex distance, hip screw placement, and neck shaft angle as potential risk factors for cut-out failure of hip screws after surgical treatment of intertrochanteric fractures.

Authors:  Hagen Andruszkow; Michael Frink; Cornelia Frömke; Amir Matityahu; Christian Zeckey; Philipp Mommsen; Stefanie Suntardjo; Christian Krettek; Frank Hildebrand
Journal:  Int Orthop       Date:  2012-08-12       Impact factor: 3.075

2.  Proximal Femoral Nail Unlocked versus Locked (ProFNUL): a protocol for a multicentre, parallel-armed randomised controlled trial for the effect of femoral nail mode of lag screw locking and screw configuration in the treatment of intertrochanteric femur fractures.

Authors:  Arjun Sivakumar; Dominic Thewlis; Andreas Ladurner; Suzanne Edwards; Mark Rickman
Journal:  BMJ Open       Date:  2020-02-10       Impact factor: 2.692

3.  Femoral neck shaft angle in relation to the location of femoral stress fracture in young military recruits: femoral head versus femoral neck stress fracture.

Authors:  Dong-Kyu Kim; Tae Ho Kim
Journal:  Skeletal Radiol       Date:  2020-11-03       Impact factor: 2.199

  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.