Topography and field effects in secondary ion mass spectrometry--part I: conducting samples.

Quantitative chemical characterization of surfaces with topography by secondary ion mass spectrometry (SIMS) remains a significant challenge due to the lack of systematic and validated measurement methods. In this study, we combine an experimental approach using a simple model system with computer simulation using SIMION, to understand and quantify the key factors that give rise to unwanted topographic artefacts in SIMS images of conducting samples with microscale topography. Experimental data are acquired for gold wires (diameters 33 to 125 μm) mounted onto silicon wafers. Significant loss of ion intensities and shadowing arise from the distortion of the extraction field, and the chemical analysis over the whole of the sample surface is difficult. For large primary ion incidence angles of ≥55° to the surface normal, a fraction of the primary ions are scattered from the target and impact the substrate, emitting secondary ions that may be mistaken as originating from the wire. For conducting samples, topographic field effects may be reduced by the use of a smaller extraction voltage and an extraction delay. The effects of an extraction delay on ion intensities, mass resolution and time-of-flight are studied, and its application is demonstrated on an anisotropically etched silicon sample. The use of a simple sample holder with a V-shaped groove to reduce topographic field effects for wires is also presented. Using these results, we provide clear guidance to analysts for the diagnosis and identification of topography effects in SIMS, and present key recommendations to minimize them in practical analysis. © Crown Copyright 2011. Reproduced by permission of the Controller of Her Majesty's Stationery Office and the Queen's printer for Scotland, 2011