| Literature DB >> 21666672 |
Hai Huang1, Laurence O Trussell.
Abstract
Little is known about which ion channels determine the resting electrical properties of presynaptic membranes. In recordings made from theEntities:
Mesh:
Substances:
Year: 2011 PMID: 21666672 PMCID: PMC3133966 DOI: 10.1038/nn.2830
Source DB: PubMed Journal: Nat Neurosci ISSN: 1097-6256 Impact factor: 24.884
Fig. 1Identification of presynaptic KCNQ current. (a) A slow voltage ramp (13 mV/s) with a K+-based internal solution evoked an outward current (black trace) that was strongly inhibited by 10-20 μM XE991, a KCNQ channel blocker (gray trace). The outward current was blocked by another KCNQ channel blocker linopirdine (b), while potentiated by KCNQ channel opener flupirtine (c) or retigabine (d). All traces were recorded in the presence of CdCl2, tetrodotoxin, CsCl, 4-AP and TEA-Cl to block the Ca2+, Na+, Ih, and Kv1 and Kv3 channels (see Methods).
Fig. 2Voltage dependence of presynaptic KCNQ current. (a) A slow voltage ramp (8 mV/s) evoked an outward current (black) which was partially blocked by 20 μM XE991 (gray). (b) XE991-sensitive current from panel A (digital subtraction of gray from black trace in panel A). From the expanded figure (c), the activation KCNQ current is apparent at about −85 mV. (d) Conductance-voltage curve of the KCNQ current. Gray line is the Boltzmann fit. (e) Current-voltage relation in the presence of 200 μM Cd2+ and 1 μM TTX. Black: control, dark gray: 10 μM XE991, light gray: subtraction of XE991 curve from control curve. (f) Conductance-voltage curve of the KCNQ current from (e). Gray line is Boltzmann fit, with parameters as indicated. (g) Depolarizing pulse from −80 mV to −40 mV evoked an outward current recorded in the absence of channel blockers (black). The outward current is largely suppressed by XE991, leaving a smaller outward current with a fast inactivating component (gray). (h) XE 991 sensitive current obtained from the subtraction of traces in panel g. The current activation was fitted by an exponential function (gray line) with fast and slow components of 35 ms (67%) and 852 ms, and a weighted time constant of 308 ms.
Fig. 3KCNQ5 is expressed in the calyx of Held. (a-c) show absence of labeling for KCNQ2-4, respectively, while panel d shows strong labeling for KCNQ5. Confocal settings were identical for panels a-d. (e) Labeling for KCNQ5 in a slice in which a calyx had been recorded and filled with biocytin (f). (g) Shows overlay of biocytin and KCNQ5 label, indicating that the channel is expressed in the calyx of Held. (h) In another slice, KCNQ5 labeling was performed after filling a postsynaptic cell (i) with biocytin. Overlay in (j) shows no postsynaptic somatic expression of the channel. Scale bar in (a) is 20 μm and applies to a-d; Scale bar in e is 5 μm and applies to panels e-f. The KCNQ current was inhibited by diclofenac (k) while potentiated by UCL2077 (l). All traces in g-h were recorded in the presence of CdCl2, tetrodotoxin, CsCl, 4-AP and TEA-Cl to block the Ca2+, Na+, Ih, and Kv1 and Kv3 channels (see online Methods).
Fig. 4Effects of KCNQ channels on resting membrane properties of calyces. (a) Bath application of 10 μM XE991 depolarized resting membrane potential (RMP) by about 5 mV (n=8). (b) Bath application of 20 μM flupirtine hyperpolarized the RMP. (c-d) 10-20 μM XE991 depolarized the membrane and decreased resting conductance (n=7). (e-f) 20 μM flupirtine hyperpolarized the calyx and increased resting conductance (n=4). Conductance was estimated in current clamp with small positive and negative current steps around the RMP. (g) In the presence of 10 μM XE991, 10 nM margatoxin strongly depolarized the membrane. (h) Margatoxin by itself had no significant effect on the resting membrane potential. (i) Mean voltage changes produced by margatoxin, XE991, or margatoxin plus XE991. Voltage change induced by margatoxin alone was not significantly different from zero (p=0.23, n=4). Voltage changes induced by XE991 and by XE991 + margatoxin were significant (p=0.003, n=5 and p=0.0003, n=5 respectively), and were significantly different from one another (19.2±1.4 mV, p=0.002, n=5). Error bars show ± S.E.M..
Fig. 5KCNQ channels determine properties of subthreshold stimuli. (a-b) Puff application of isoguvacine (0.2 mM, 100 ms) evoked depolarized responses (black trace), whose amplitude was potentiated and whose decay was slowed , by 10 μM XE991 (gray trace). (c) under voltage-clamp, isoguvacine-induced current was not affected by XE991. (d-g) Synaptic-like waveforms (rise time constant 7.5 ms, decay time constant 25 ms; black trace in d) of different amplitudes were injected into the calyx. Voltage responses are shown in black traces while gray traces show responses recorded with 10 μM XE991. Voltage response traces are averages of 4-8 applications. (h-i) Statistical data summarize XE991 effects on response amplitudes (h) and half width (i). Error bars show ± S.E.M..
Fig. 6Modulation of KCNQ current by PIP2 and PKC. (a-b) A slow voltage ramp (13 mV/s; a) or a voltage step from −80 mV to −30 mV (b) evoked an outward KCNQ current (black), which was partially inhibited by PI4 kinase inhibitor PAO (50 μM; gray). (c) PAO positively shifted the conductance-voltage curve. (d-e) 2 μM PMA, a potent protein kinase C activator, also inhibited the outward KCNQ current evoked by voltage ramp (d) or a voltage step (e). Inset in (d) shows that the PMA effects were blocked by PKC inhibitory peptide PKC19-31. Voltage ramp was from −100 to +20 mV as in main panel. (f) PMA has no effects on conductance-voltage relationship. All traces were recorded in the presence of CdCl2, TTX, CsCl, and 4-AP to block the Ca2+, Na+, Ih, and Kv1 and Kv3 channels. Boltzmann fit parameters given in text. Error bars show ± S.E.M..
Fig. 7Regulation of transmitter release by KCNQ channels. (a-b) Application of 10 μM XE991 increased the first EPSC amplitude but has a smaller effect on the second EPSC in a pair-pulse protocol. (c) XE991 significantly decreased paired-pulse ratio. (d) Ten μM flupirtine decreased the first EPSC amplitude but with smaller effect on the second EPSC. (e) The calyx was first preconditioned by 20 Hz stimuli for 10 s, followed immediately by a period of 100 Hz stimuli. Ten μM XE991 increased all EPSCs but to different degrees. Each trace is an average of 4–10 recordings. Error bars show ± S.E.M..