OBJECTIVE: This study examined the effect of flute number and cross-sectional area on the cutting efficiency of 3 reciprocating endodontic instruments twisted from rectangular stainless steel wire; 40/0.02 instruments at 25-mm length were compared. STUDY DESIGN:Seventy-five anterior teeth were prepared, divided into 3 groups, and operated on with a reciprocating handpiece at 2500 rpm for 5 seconds at around 500 grams of force: Group 1, SafeSiders; Group 2, Dentsply K-Files; Group 3, Dentsply K-Reamers. Dentin generated was collected in weigh dishes. Cutting efficiency was determined by dentin weight. Statistical analysis was performed with 1-way ANOVA and the Student-Neuman-Keuls (SNK) multiple comparisons testing. RESULTS: SafeSider instruments produced a greater amount of debris than K-Files and K-Reamers (P < .026). K-Files and K-Reamers were not statistically different (P = .63). CONCLUSIONS: Flute number had no effect on cutting efficiency. Cross-sectional area may be a determining factor on cutting efficiency. Copyright (c) 2010 Mosby, Inc. All rights reserved.
RCT Entities:
OBJECTIVE: This study examined the effect of flute number and cross-sectional area on the cutting efficiency of 3 reciprocating endodontic instruments twisted from rectangular stainless steel wire; 40/0.02 instruments at 25-mm length were compared. STUDY DESIGN: Seventy-five anterior teeth were prepared, divided into 3 groups, and operated on with a reciprocating handpiece at 2500 rpm for 5 seconds at around 500 grams of force: Group 1, SafeSiders; Group 2, Dentsply K-Files; Group 3, Dentsply K-Reamers. Dentin generated was collected in weigh dishes. Cutting efficiency was determined by dentin weight. Statistical analysis was performed with 1-way ANOVA and the Student-Neuman-Keuls (SNK) multiple comparisons testing. RESULTS: SafeSider instruments produced a greater amount of debris than K-Files and K-Reamers (P < .026). K-Files and K-Reamers were not statistically different (P = .63). CONCLUSIONS: Flute number had no effect on cutting efficiency. Cross-sectional area may be a determining factor on cutting efficiency. Copyright (c) 2010 Mosby, Inc. All rights reserved.