PURPOSE: The objective of this study was to formulate and evaluate freeze-dried black raspberry (FBR) ethanol extract (RE) loaded poly(DL-lactic-co-glycolic acid) (PLGA) and poly(DL-lactic acid) (PLA) injectable millicylindrical implants for sustained delivery of chemopreventive FBR anthocyanins (cyanidin-3-sambubioside (CS), cyanidin-3-glucoside (CG) and cyanidin-3-rutinoside (CR)). METHODS: Identification and quantitation of CS, CG, and CR in RE was performed by mass spectroscopy and HPLC. RE:triacetyl-beta-cyclodextrin (TA-beta-CD) inclusion complex (IC) was prepared by a kneading method and characterized by X-ray diffraction (XRD), nuclear magnetic resonance spectroscopy (NMR) and UV-visible spectroscopy. RE or RE:TA-beta-CD IC-loaded PLGA or PLA implants were prepared by a solvent extrusion method. In vitro and in vivo controlled release studies were conducted in phosphate-buffered saline Tween-80 (pH 7.4, 37 degrees C) and after subcutaneous administration in male Sprague-Dawley rats, respectively. Anthocyanins were quantified by HPLC at 520 nm. RESULTS: The content of CS, CG, and CR in RE was 0.2, 1.5, and 3.5 wt%, respectively. The chemical stability of anthocyanins in solution was determined to be pH-dependent, and their degradation rate increased with an increase in pH from 2.4 to 7.4. PLGA/PLA millicylindrical implants loaded with 5 or 10 wt% RE exhibited a high initial burst and short release duration of anthocyanins (35-52 and 80-100% CG + CR release after 1 and 14 days, respectively). The cause for rapid anthocyanins release was linked to higher polymer water uptake and porosity associated with the high osmolytic components of large non-anthocyanin fraction of RE. XRD, (1)H NMR and UV-visible spectroscopy indicated that the non-anthocyanin fraction molecules of RE formed an IC with TA-beta-CD, decreasing the hydrophilicity of RE. Formation of an IC with hydrophobic carrier, TA-beta-CD, provided better in vitro/in vivo sustained release of FBR anthocyanins (16-24 and 97-99% CG + CR release, respectively, after 1 and 28 days from 20 wt% RE:TA-beta-CD IC/PLA implants) over 1 month, owing to reduced polymer water uptake and porosity. CONCLUSION: PLA injectable millicylindrical implants loaded with RE:TA-beta-CD IC are optimal dosage forms for 1-month slow and continuous delivery of chemopreventive FBR anthocyanins.
PURPOSE: The objective of this study was to formulate and evaluate freeze-dried black raspberry (FBR) ethanol extract (RE) loaded poly(DL-lactic-co-glycolic acid) (PLGA) and poly(DL-lactic acid) (PLA) injectable millicylindrical implants for sustained delivery of chemopreventive FBRanthocyanins (cyanidin-3-sambubioside (CS), cyanidin-3-glucoside (CG) and cyanidin-3-rutinoside (CR)). METHODS: Identification and quantitation of CS, CG, and CR in RE was performed by mass spectroscopy and HPLC. RE:triacetyl-beta-cyclodextrin (TA-beta-CD) inclusion complex (IC) was prepared by a kneading method and characterized by X-ray diffraction (XRD), nuclear magnetic resonance spectroscopy (NMR) and UV-visible spectroscopy. RE or RE:TA-beta-CD IC-loaded PLGA or PLA implants were prepared by a solvent extrusion method. In vitro and in vivo controlled release studies were conducted in phosphate-buffered saline Tween-80 (pH 7.4, 37 degrees C) and after subcutaneous administration in male Sprague-Dawley rats, respectively. Anthocyanins were quantified by HPLC at 520 nm. RESULTS: The content of CS, CG, and CR in RE was 0.2, 1.5, and 3.5 wt%, respectively. The chemical stability of anthocyanins in solution was determined to be pH-dependent, and their degradation rate increased with an increase in pH from 2.4 to 7.4. PLGA/PLA millicylindrical implants loaded with 5 or 10 wt% RE exhibited a high initial burst and short release duration of anthocyanins (35-52 and 80-100% CG + CR release after 1 and 14 days, respectively). The cause for rapid anthocyanins release was linked to higher polymerwater uptake and porosity associated with the high osmolytic components of large non-anthocyanin fraction of RE. XRD, (1)H NMR and UV-visible spectroscopy indicated that the non-anthocyanin fraction molecules of RE formed an IC with TA-beta-CD, decreasing the hydrophilicity of RE. Formation of an IC with hydrophobic carrier, TA-beta-CD, provided better in vitro/in vivo sustained release of FBRanthocyanins (16-24 and 97-99% CG + CR release, respectively, after 1 and 28 days from 20 wt% RE:TA-beta-CD IC/PLA implants) over 1 month, owing to reduced polymerwater uptake and porosity. CONCLUSION: PLA injectable millicylindrical implants loaded with RE:TA-beta-CD IC are optimal dosage forms for 1-month slow and continuous delivery of chemopreventive FBRanthocyanins.
Authors: Catarina Marques Fernandes; Pedro Ramos; Amílcar Celta Falcão; Francisco José Baptista Veiga Journal: J Control Release Date: 2003-02-14 Impact factor: 9.776
Authors: S R Mallery; P Pei; J Kang; G M Ness; R Ortiz; J E Touhalisky; S P Schwendeman Journal: Anticancer Res Date: 2000 Sep-Oct Impact factor: 2.480
Authors: Boudewijn J M Braakhuis; Maarten P Tabor; C René Leemans; Isaac van der Waal; Gordon B Snow; Ruud H Brakenhoff Journal: Head Neck Date: 2002-02 Impact factor: 3.147
Authors: Bruce C Casto; Laura A Kresty; Carrie L Kraly; Dennis K Pearl; Thomas J Knobloch; Herman A Schut; Gary D Stoner; Susan R Mallery; Christopher M Weghorst Journal: Anticancer Res Date: 2002 Nov-Dec Impact factor: 2.480
Authors: James P Malone; Julie A Stephens; John C Grecula; Chris A Rhoades; Bobak A Ghaheri; David E Schuller Journal: Head Neck Date: 2004-07 Impact factor: 3.147
Authors: Radha Munagala; Farrukh Aqil; Jeyaprakash Jeyabalan; Ashish K Agrawal; Ashley M Mudd; Al Hassan Kyakulaga; Inder P Singh; Manicka V Vadhanam; Ramesh C Gupta Journal: Cancer Lett Date: 2017-02-12 Impact factor: 8.679