PURPOSE: There is a consensus in the community of dental research that the selection of undersized artificial maxillary anterior teeth offers an unnatural appearance to the denture. Several methods to select the adequate width of these teeth are of questionable validity, and many dentures have an obviously artificial appearance. This article assessed the relationship between the individual and the combined width of maxillary anterior teeth. MATERIALS AND METHODS: Impressions were made of the anterior dentition of 69 dentate undergraduate students with rubber impression silicon, and casts were formed. The individual widths of the maxillary anterior teeth were measured by using a digital caliper (SC-6 digital caliper, Mitutoyo Corporation, Tokyo, Japan), and the combined width was registered by both adding the individual width and using a flexible millimeter ruler. RESULTS: Student's t-test showed significant differences between the analogous teeth and different sides of the maxillary dental arch (p = 0.001), with the exception of the central incisor (p = 0.984). Pearson's product moment correlation coefficient showed significant positive correlation between all the measurements compared (p = 0.000). Linear regression analysis concluded three mathematical equations to obtain the individual tooth width after measuring the combined width of the six maxillary anterior teeth by using a flexible millimeter ruler. CONCLUSIONS: The individual tooth width can be determined if the combined width of the maxillary anterior teeth is obtained by using a flexible millimeter ruler.
PURPOSE: There is a consensus in the community of dental research that the selection of undersized artificial maxillary anterior teeth offers an unnatural appearance to the denture. Several methods to select the adequate width of these teeth are of questionable validity, and many dentures have an obviously artificial appearance. This article assessed the relationship between the individual and the combined width of maxillary anterior teeth. MATERIALS AND METHODS: Impressions were made of the anterior dentition of 69 dentate undergraduate students with rubber impression silicon, and casts were formed. The individual widths of the maxillary anterior teeth were measured by using a digital caliper (SC-6 digital caliper, Mitutoyo Corporation, Tokyo, Japan), and the combined width was registered by both adding the individual width and using a flexible millimeter ruler. RESULTS: Student's t-test showed significant differences between the analogous teeth and different sides of the maxillary dental arch (p = 0.001), with the exception of the central incisor (p = 0.984). Pearson's product moment correlation coefficient showed significant positive correlation between all the measurements compared (p = 0.000). Linear regression analysis concluded three mathematical equations to obtain the individual tooth width after measuring the combined width of the six maxillary anterior teeth by using a flexible millimeter ruler. CONCLUSIONS: The individual tooth width can be determined if the combined width of the maxillary anterior teeth is obtained by using a flexible millimeter ruler.