| Literature DB >> 18311565 |
Kerstin Greulich1, Lutz Alder.
Abstract
The study tested the determination of 300 pesticides in mineral water at levels of 0.1 and 1.0 microg/L. Measurements were conducted by direct sample injection into a liquid chromatograph coupled to a tandem mass spectrometer without any sample enrichment and/or cleanup. Two separate injections enabled the recording of two transitions per analyte (600 selected reaction monitoring transitions in total). For 285 analytes the sensitivity of direct sample injection (100 microL) was sufficient to quantify residues at 0.1 microg/L. All remaining pesticides were detected at 1.0 microg/L. Calibration functions were linear for more than 80% of analytes. Signal suppression or enhancement compared with signals in high-performance liquid chromatography water was equal to or smaller than 20% for 240 analytes. Even the largest matrix-induced suppression did not result in the disappearance of peaks. Combining the results of seven mineral waters, the relative standard deviation of "recovery" was 20% or less for 87% of the substances. A second transition for confirmatory purposes was often available. Consequently, the proposed direct injection of samples without any sample enrichment and/or cleanup is suitable for screening of many pesticides in mineral and drinking water.Entities:
Mesh:
Substances:
Year: 2008 PMID: 18311565 DOI: 10.1007/s00216-008-1935-x
Source DB: PubMed Journal: Anal Bioanal Chem ISSN: 1618-2642 Impact factor: 4.142