AIM: This in vitro study aims to measure the temperature changes of resin luting cements cemented to human dentin when using different light curing systems for photo-activation. METHODS AND MATERIALS: The three different types of light-curing units (LCUs) used for photoactivation were quartz-tungsten halogen (QTH), light emitting diode (LED), and plasma arc (PAC). Two types of dual cure resin cements were used [Variolink II (VL) and Choice (CH)]. Feltik Z250 composite resin material was used to prepare composite discs. Thirty human dentin specimens were prepared for each resin luting cement (ten for each light source). A total of 60 specimens were fabricated. Resin cement was applied on a dentin bridge and covered with the prepared composite disc where specimens were fabricated. Temperature change was recorded with a digital thermometer. RESULTS: The lowest temperature was recorded when VL and CH were photo-activated with the PAC unit. The PAC unit produced significantly lower recorded temperatures than the LED and QTH units. No significant difference appeared between QTH and LED units in terms of recorded temperature. CONCLUSION: The PAC unit produced significantly lower temperature changes compared to QTH and LED curing units. The risk for temperature rise should be taken into consideration during photo-polymerization of adhesive resins with LED or QTH in deep cavities when dentin thickness is 0.5 mm.
AIM: This in vitro study aims to measure the temperature changes of resin luting cements cemented to human dentin when using different light curing systems for photo-activation. METHODS AND MATERIALS: The three different types of light-curing units (LCUs) used for photoactivation were quartz-tungsten halogen (QTH), light emitting diode (LED), and plasma arc (PAC). Two types of dual cure resin cements were used [Variolink II (VL) and Choice (CH)]. Feltik Z250 composite resin material was used to prepare composite discs. Thirty human dentin specimens were prepared for each resin luting cement (ten for each light source). A total of 60 specimens were fabricated. Resin cement was applied on a dentin bridge and covered with the prepared composite disc where specimens were fabricated. Temperature change was recorded with a digital thermometer. RESULTS: The lowest temperature was recorded when VL and CH were photo-activated with the PAC unit. The PAC unit produced significantly lower recorded temperatures than the LED and QTH units. No significant difference appeared between QTH and LED units in terms of recorded temperature. CONCLUSION: The PAC unit produced significantly lower temperature changes compared to QTH and LED curing units. The risk for temperature rise should be taken into consideration during photo-polymerization of adhesive resins with LED or QTH in deep cavities when dentin thickness is 0.5 mm.