OBJECTIVE: To analyze effects of different thread helix angles and densities on the primary stability of immediately loaded implants using the three-dimensional finite element model analysis. METHODS: Five models of three-dimensional finite element (0.8 mm, 1.6 mm, 2.4 mm, double-threaded, and triple-threaded) were created using the commercial codes of Pro/E software, Hypermesh software, and ABAQUS software. In conditions of horizontal and vertical loading, the micro-motion of the finite element models with different thread helix angles and densities were computed with ABAQUS software. RESULTS: Concerning different thread helix angles, the micro-motion of single-threaded implant was the minimum and that of the triple-threaded was the maximum with vertical and horizontal loading. The micro-motion of doubled-threaded implant was the minimum compared with thread pitch 1.6 mm and the micro-motion of triple-threaded implant was the minimum compared with thread pitch 2.4 mm with vertical and horizontal loading. CONCLUSIONS: The thread helix angle and density of implants can greatly affect the vertical interfacial micro-motion. With increasing thread pitchs, the resistance of implant to vertical load is weakened; with increasing thread helix angle, the resistance of implant to vertical load is weakened; with increasing thread density, the resistance of implant to the vertical load is weakened.
OBJECTIVE: To analyze effects of different thread helix angles and densities on the primary stability of immediately loaded implants using the three-dimensional finite element model analysis. METHODS: Five models of three-dimensional finite element (0.8 mm, 1.6 mm, 2.4 mm, double-threaded, and triple-threaded) were created using the commercial codes of Pro/E software, Hypermesh software, and ABAQUS software. In conditions of horizontal and vertical loading, the micro-motion of the finite element models with different thread helix angles and densities were computed with ABAQUS software. RESULTS: Concerning different thread helix angles, the micro-motion of single-threaded implant was the minimum and that of the triple-threaded was the maximum with vertical and horizontal loading. The micro-motion of doubled-threaded implant was the minimum compared with thread pitch 1.6 mm and the micro-motion of triple-threaded implant was the minimum compared with thread pitch 2.4 mm with vertical and horizontal loading. CONCLUSIONS: The thread helix angle and density of implants can greatly affect the vertical interfacial micro-motion. With increasing thread pitchs, the resistance of implant to vertical load is weakened; with increasing thread helix angle, the resistance of implant to vertical load is weakened; with increasing thread density, the resistance of implant to the vertical load is weakened.